Replacement Hub, Drum and Brake Assemblies for AL KO 3,500 lb Axle
I have a 2008 Flagstaff camper with two Alko axles. It is in need of new brakes/drums. Ive attached a photo of the plate attached to the front axle. Could you reference me to the proper parts, drums and brakes, including seals and dust caps...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Troubleshooting Curt Trutrac System Digging Into Brackets
I recently purchased the Curt Trutrac WD C17501 for my 2004 Ford Excursion towing a 39ft travel trailer. The tongue weight loaded is around 1100 lb. The RV dealership installed the weight distribution on my trailer and set it up but after driving...
Looking for Replacement Locking End Caps for Rhino Rack Aero Roof Rack
hi- i am wondering if rhino rack locking end cap part m622 is available to purchase and what size security key is used to operate. thank you in advance for your time. chris baer | Hey Christopher, it sounds like you are looking for a replacement...
What Hitch Ball Size Do They Use in Europe
is hich ball the same size as europe | We currently carry four different size hitch balls which are 1-7/8", 50mm, 2", and 2-5/16". The most common hitch ball size in Europe is 50mm for which you can use part # 63912 if you need a 3/4" diameter...
Recommended Air Bags for a 2005 Ford Econoline 350 w/ a V10
I have a 2005 Ford Econoline 350 with V10. It has a 3 inch lift. Do you have any rear air suspension products that would work with the lift. I want to tow with it and I am a huge fan of of the rear suspension airbag systems. | Hey Russell, we...
Air Bag and Auto Leveling Compressor kit for 2003 Ford Excursion
Hi. I would like to install air bags on my Excurion 2003 4wd diesel. I would like it to auto level and not have to mess with bicycle pumps etc. Is there a kit for that? Thanks | Hey Pete, we have just what you are looking for with the Firestone...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
What Rack System Can I Use On My 2002 Ford Excursion With Factory Side Tracks
Will this fit the factory tracks of a 2002 ford excursion? | Great question, Dave! After some double checking I can confirm that Rhino Rack part # Y02-480B-NT will work on the factory tracks on the roof of your 2002 Ford Excursion. What are...
What is Max Amperage Draw of Bulldog Winch Light Duty On-Board Air Compressor
What is the maximum amp draw of this compressor? | Hey Michael, the Bulldog Winch Light Duty On-Board Air Compressor # BDW46TJ draws at max just under 40 amps. |
Looking For A Shocker Hitch For My 2003 Ford Excursion Pulling A 7k Trailer
I am interested in a shocker hitch. I have a 2003 ford excursion, 7.3 l diesel with 4 wheel drive. I primarily pull a RV that weighs 7,000 lbs. What model do you recommend? thanks | Hey Patrick, The Shocker Hitch # SHK47VR would be a solid...
Front Hitch for 2006 Jeep Commander to Mount SnowBear Personal Snowplow
Mounting bracket for snow bear personal plow to fit 2006 Jeep commander | Since the SnowBear Personal Snowplow part # SB324-081 is designed to attach to a front hitch what you'll need is a front hitch designed to fit your 2006 Jeep Commander...
Replacement Side Marker Lights For A 2015 OEM Can AM RT622 Motorcycle Trailer
I have a 2015 OEM Can Am RT622 motorcycle trailer and need Replacement LED Side Marker lights YELLOW in the front RED in the back they are obsolete and I can not get them anymore and was wondering if you would be able to help find a replacement...
Looking For Replacement Weather Stripping For Lift Gate On 2003 Ford Excursion
I need to replace the weather stripping for the lift gate on my 2003 Ford Excursion and the OEM Part 2C7Z-78404A06-AA has been discontinued. I have been searching junk yards and the internet for something that might work. Might you have something...
Troubleshooting Open Ground Warning on P3 with Known Solid Ground Connection
I have the Prodigy P3 installed on my 2003 Excursion 6.0L diesel using the 3035-P adapter. Intermittently I get the Open Ground No Brakes warning message. No trailer connected. I checked the batteries negative terminal to chassis in the engine...
Replacement 4-Way and 7-Way Connector for a 2007 Jeep Commander w/ a Factory 7-Way
I would like to remove factory 7 pin harness and install A new 4 pin harness 2007 Jeep Commander Trailor brakes not needed old harness has been butchered | Hey Anthony since you had the factory 7-way you'll need the Curt T-Connector Vehicle...
Trailer Turn Signals Not Working with # C55050 Wiring Harness Installed on a 2008 Jeep Commander
I have the 118408 converter connected to my 2008 jeep commander i everything works fine at the plug, when I plug in the only lights that work are the running lights, with running lights off, if I turn on a blinker and step on the brake the brake...
Recommended 3-Prong 3-Wire Pigtail for a Optronics Trailer Tail Light
Good evening, I am inquiring if there is a 3 prong 3 wire plug for this brake light STL29RB that I could solder and then plug into a existing wire harness for a trailer. Thanks. | Yes, there is Jeff. We actually have three different 3 prong...
Is There a Reason Demco 50-Degree A-Frame Coupler # DM15349-52 is Silver
Why is the powder coated silver? Seems to me most trailer types that this would go on would be black. Are they sold in black also? | Silver is just the color that Demco likes for their couplers which is why the Demco 50-Degree A-Frame Coupler...
Recommended Factory Replacement Hitch for a 2000 Ford Excursion
2000 Ford Excursion with towing package. The current Ford hitch has an electrical connection in a steel frame to the left of the hitch. I don't see that on the CURT 14011 Class 4 Trailer Hitch. Do I have to remove the current electrical connection...
How Does the Reese Friction Sway Control Kit Attach to the Hitch?
SWAY BARS: Regarding the hitch mounted ball for the sway bar, is the frame that the ball is mounted to an welded integral part of the trailer hitch or is this frame mounted under the main 2 ball? | Hey Larry! The Reese Friction Sway Control...
Will Blue Ox SwayPro WDH Fit V Nose Trailer
Good afternoon, I have a 8x20 V nose enclosed car hauler trailer with not much room on the tongue. Usually when it’s loaded the tongue weight is around 1,200-1,300 pounds. I’ve been pulling it okay since my old tow vehicle had air bags but...
Will Redarc Tow Pro Brake Controller Fit 2010 Jeep Commander with 7-Way
I have a 2010 Jeep Commander 5.7L and a 21foot expandable trailer. Will the Redarc Tow Pro elite work and if so, what additional pieces are needed for the install? I already have a Mopar Electric Trailer Brake Controller Harness 82210512ACinch...
Does Centering Keel Roller # CE29505 Come with Install Brackets
Mine has 8” bracket does the new one come with replacement bracket? | The self centering roller part # CE29505 does not come with a mounting bracket but for that we have the # CE10305G for a bracket and for a roller # CE10727A which includes...
Filter Your Search
Contact and Help