Yes, for the white version of the MaxxFan Deluxe Roof Vent with 12 volt fan, thermostat, remote and powered lift we have the part #MA00-07000K which is exactly what you need.
Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…
We have the Multi-Purpose Access Door for RVs, #37231025. This is a 6-3/4" diameter hatch that requires a 5-1/2" diameter cutout. This threaded design easily twists off to provide instant access to…
The USB Outlet with Waterproof Cap #DG61USBVP requires a 1-1/8" depth without the cap. The cap for the face has a ring that slides onto the shaft and is approximately 5/16" thick. If you plan on using the cap…
The series name for a travel trailer (and the specific trailer's VIN) are helpful when communicating with the trailer's original manufacturer but in terms of finding replacement parts you really do not need…
Your power cord, just like with the Mighty Cord #A10-5025END will wire the black and red wires as your positive, white as your neutral, and green as your ground. The green wire should not be sticking out of the sleeve like you have pictured and the…
The "20327-02" light base is a rectangular shaped clearance light measuring 4" long x 2" wide which was made by Optronics. The light has since been discontinued along with the…
The SmartPlug RV TV/Internet Inlet #SM28VR is the closest option we offer to the BDCOAXECPB. This comes with a coaxial connector and blank port for you to install an ethernet port from your local electronics/electrical supply store into.
Short answer, yes you can convert from 30amp to 50 amp. It will be costly and require an electrician. Long answer, you will need to replace the power outlet with SmartPlug RV and Marine Power Inlet - 50 Amp - Stainless Steel #SM79FR. Then replace…
The Yakima OffGrid basket #Y07138 has the ability to be locked by adding lock set #Y07204. The locks will install in the basket mounting hardware and when locked the basket will not be able to be removed from the roof rack. I have included a link…
To convert to disc brakes, you will need to check the bearings on your current hubs. If you pull the hub you should find on the inner and outer bearing a number printed on each. Those numbers will help to confirm the fit on your spindle. If you…
Filter Results
