RV Couches and Chairs Specs:
Features:
This swivel glider recliner with PolyHyde vinyl upholstery has a remote-controlled heat function to keep you warm. The base allows the recliner to swivel 360-degrees, and glide back and forth. Hardware is included for minimal assembly.
More Information >Videos
for RV Couches and Chairs
Help Articles
for RV Couches and Chairs
Expert Answers
for RV Couches and Chairs
The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…
view full answer...Yes, the Thomas Payne Trifold RV Loveseat #TP59FR will fit in a 68-1/4" opening. You will want to ensure your door has a 26" or larger opening to get the couch inside.
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…
view full answer...Hey Cliff, with the Replacement Controlled Motion Hinge #LC95VR to get the desired effect where the door doesn't swing open or closed all you have to do is replace is a single hinge and not all three.
view full answer...The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That…
view full answer...To replace your Atwood RV Water Heater, Model #GC10A-4E, the direct replacement is the Atwood RV Water Heater - Gas and Electric - part #AT94022. This is the new version of your existing water heater, so it will have all the same features like a…
view full answer...Definitely a smart idea to replace your Atwood heater with a tankless unit, as they are much more energy-efficient and quicker to heat your water. We do have an option that will easily fit in place of your 16" x 15-1/2" x…
view full answer...If you're referring to the connection between the trailer and the pin box then yes, the MORryde Cushioned 5th Wheel Pin Box #MR83QR would be a match for the Lippert Rhino Box bolt pattern on your trailer. If you're talking about the…
view full answer...The overall dimension you are measuring is the length of the outer tube of the jack. If you check out the first picture I attached you'll see where the part #LG-1 measures 29-1/2 inches in length. The second picture I attached shows the…
view full answer...I reached out to Lippert who informed me your Power Gear controller 140-1224 Rev 0G is obsolete. It was replaced with the Lippert part number 372854 but that part is also now obsolete. At this point your options are to try and have your controller…
view full answer...The Hydrastar Extra Capacity Reservoir #HS85-1020 will sit directly on top of your current Hydrastar system to add an additional 1 quart of capacity. I do have a picture that I have included of the reservoir mounted on top of their main unit. We…
view full answer...Jameson's wording could've been better but what he meant was that there isn't any way to adjust the connection point of the Curt CrossWing Lightweight #C92DR since it only allows for you to raise of lower the hitch head. In…
view full answer...