RV Couches and Chairs Specs:
Features:
This swivel glider recliner with PolyHyde vinyl upholstery has a remote-controlled heat function to keep you warm. The base allows the recliner to swivel 360-degrees, and glide back and forth. Hardware is included for minimal assembly.
More Information >Videos
for RV Couches and Chairs
Help Articles
for RV Couches and Chairs
Expert Answers
for RV Couches and Chairs
The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…
view full answer...Hey Cliff, with the Replacement Controlled Motion Hinge #LC95VR to get the desired effect where the door doesn't swing open or closed all you have to do is replace is a single hinge and not all three.
view full answer...The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar.…
view full answer...To replace your Atwood RV Water Heater, Model #GC10A-4E, the direct replacement is the Atwood RV Water Heater - Gas and Electric - part #AT94022. This is the new version of your existing water heater, so it will have all the same features like a…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have…
view full answer...Since you are replacing the your Dometic Duo-Therm 59016.526 and the thermostat I recommend using the Furrion Chill HE RV Air Conditioner System #FR55PV. This is also a 15K btu system which includes a new roof mounted AC, air distribution box,…
view full answer...To charge the battery in the Engager Trailer BreakAway Kit, #20099, you can attach the wire from the 12 volt circuit on the trailer side 7-Way (1 oclock position on the back of the trailer side 7-Way where the wires attach) to the input wire on the…
view full answer...There could be a number of causes as to why your Everchill RV Refrigerator w/ Freezer #324-000119 is malfunctioning. I would start by removing the fuse to fully cut the power and waiting a few minutes for the unit to fully reset. If resetting the…
view full answer...The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and…
view full answer...A slider 5th wheel trailer hitch is one option to get more clearance when making tight turns. They are not just for backing up because you could be going backwards or forwards when turning and need the clearance. The other option is to replace the…
view full answer...The silver capture plates on the Demco Hijacker Autoslide Hitch #DM8550034 should be adjusted after you hitch the trailer. You want to push the capture plates against both sides of the pin box then finger-tighten the inside jam nuts against the…
view full answer...If you have been upkeeping with the care and maintenance on your 18K Demco Hijacker Autoslide #DM8550034 it sounds like you might need to mess with the gear adjustment bolt located on the cab-end of the Hijacker. To do this you need to place the…
view full answer...Filter Products (2)
Contact and Help
What our customers are saying:
I just wanted to say that i am incredibally impressed with every aspect of my purchase with your company. I was very skeptical about ordering anything online, i have only purchased ONE item online other that this one. I comparison shopped both online as well as local stores ([..], [..], [..], [..], [..], [..], [..], [..] and [..])) 90% of these stores didnt have it, and if they did ([..])) it was anywhere from 50-100% more expensive. I'll make a long story short , the price was out standing, the ordering process was very simple, and i received the item exactly 3 days later (with the CHEAPEST shipping!!)) the directions were SO simple i got worried, but they were clear, concise and to the point, i COULD NOT BELIEVE how easy it was.. it took me about 30-35 minutes , and all i had to do was take out 4 bolts and put in 6. ABSOLUTELY OUTSTANDING!! i will tell everyone i know about your website, and if i EVER need parts for my 1995 JEEP WRANGLER in the future i will be purchasing it from you . Sincerely, David,
David
Chicago, IL