RV Camera System Specs:
Features:
...or camper 1 Camera, monitor, 2 monitor mounts, 12V DC power cord, 6' camera power cable, antennas, zip ties, and mounting screws are included Specs: Monitor dimensions: 5-5/8" wide x 3-3/16"...
More Information >Videos
for RV Camera System
Help Articles
for RV Camera System
Expert Answers
for RV Camera System
You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…
view full answer...Since you have a Dometic AC unit the best option to replace it from Advent would be the part #ACDOM135 which was designed for this exact situation and would allow you an easy install since the electronics would plug right in.
view full answer...Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…
view full answer...On equalizer 013-105-04 in kit #K71-360-00 the eye center to eye center measurement is approximately 7-1/2 inches.
view full answer...It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…
view full answer...To see all of the correct wheel and tire combos…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...The disc brake kits like #K2R1058D13 are designed for torsion axles and disc brake rated EOH systems which have a higher 1600 psi level than drum brake actuators. This is currently the only kit we have compatible with 10K torsion axles from Lippert…
view full answer...I cannot determine which rear bumper that you have from your picture so I will give you to options based on which bumper you have on your 1989 Chevrolet K3500 Crew Cab Pickup with the…
view full answer...There is no mounting hardware included with the Aluminum A-Frame Trailer Tongue Toolbox, item #350970, due to the different construction and mounting locations that may be required for many different styles of trailers. I would recommend using a…
view full answer...90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...