XL Kodiak ProLube 1980 Castle Nut Washer Recommendation
Question:
I am trying to change my existing hubs, with the bearing numbers mentioned, to this kit. My problem is that the washer under the castle nut is bigger than the opening in the aluminum cap. Have checked and made sure all races are set correctly. Seal is drove in as far as possible. Any recommendations would be helpful.
asked by: Joe S
0
Expert Reply:
Do you have an overly large castle nut washer? It seems odd that the washer is too big to fit in the cap of the # XLPROLUBE1980KIT. Since this kit is designed for 3.5k axles the correct replacement washer should be the # 5-23. This washer should be very similar in size to the castle nut.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Kodiak XL ProLube Kit for 3500-lb Axles
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- 1.98 Inch
- Kodiak
more information >
Continue Researching
- Q&A: Does Kodiak Disc Brake Kit KOD77FR Come with Brake Pads
- Q&A: Can Regular Grease Trailer Hubs be Converted to Oil Bath Hubs
- Q&A: Replacement Cap For Kodiak Oil Bath Disc Brakes
- Article: Trailer Wiring Diagrams
- Q&A: Converting Hubs From Grease To Oil Bath On 2014 Outback 298RE Travel Trailer
- Q&A: Need Bearing Kit For Lippert 3,500 lb Axle On 2021 Forest River Grey Wolf 23DBH
- Q&A: Can a B&W Companion 5th Wheel Hitch from a Chevy Silverado Fit a 2018 Ram 3500 Long Bed
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Instructions for Welding Brake Actuator to Trailer Frame and Bleeding Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs