What Pigtails Are Needed For Optronics Submersible LED Trailer Tail Light With Backup Lights
Updated 12/04/2014 | Published 12/03/2014
Products Featured in This Question
Question:
What connectors are required for Optronics STL 211RB? It is a stop/turn/tail light with a reverse light, and it shows two plugs on the picture. Do you use a two-prong connector A45CB for the reverse and a three-prong A45PB connector for the stop/turn/tail, or do you use two of the three-prong connectors?
asked by: Spencer R
Expert Reply:
You are correct that you will need two pigtails for this light.
I spoke with my contact at Optronics about the Trailer tail Light, part STL211RB.
One plug is to be used with a 3-wire pigtail like part # A47PB for the right angle plug or the straight 3-wire pigtail part # A45PB.
The other plug will use a 2-wire pigtail like part # A45CB, which will be used for the back-up lights only.
Product Page this Question was Asked From
2-Wire Pigtail for Optronics Backup and Utility Trailer Lights - 2-Prong PL-3 Plug
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Two Wire
- Straight Pigtail
- Optronics
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Q&A: 7-Way Wire Harness Needed For A 2024 Ram 5500
- Q&A: Is The TecNiq Side Marker With Reflector TN33TR Available In Amber?
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Parts Needed to Add Back Up Lights & 7-Way Connector on Boat Trailer
- Q&A: Replacement Marker/Clearance Lights For a 2006 Ranger Trail Boat Trailer
- Q&A: Finding Clear Trailer Light to Replace SAE R 97 DOT
- Q&A: Standard Color Code for Wiring Simple 4 Wire Trailer Lighting
- Q&A: Optronics Trailer Lights # STL70RB and # LED Light Brightness
- Article: Trailer Lighting Requirements
- Article: How to Measure a Trailer Axle
- Article: Anti-Rattle Devices