Does Bolt for Timbren Front Suspension Enhancement System # TFF350SDC Match the OEM Bolt
Updated 11/20/2014 | Published 11/19/2014
Question:
before I start to install the front Timbren, the OEM mount used one bolt only into the frame, no nut on the other end. My question is if Timbren has the same size of thread on supplied bolt that will match the OEM bolt ? I dont want to pry out the bump stop then find out the thread is different.....
asked by: Paul T
Expert Reply:
I spoke with my contact at Timbren and he said the bolt supplied with your Timbren Front Suspension Enhancement System # TFF350SDC that goes from axle to frame should match the OEM bolt. If not, you can use the factory bolt.
I have included a link to the installation instructions at right.
Product Page this Question was Asked From
Timbren Front Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Front Axle Suspension Enhancement
- Timbren
more information >
Continue Researching
- Q&A: Will Adding Timbrens to My Ford F-350 Super Duty Help with the Chucking When Towing 5th Wheel?
- Q&A: Is There Weight Capacity for Brophy Camper Tie Downs
- Q&A: Which Timbren Suspension Enhancement Kit Fits a 2006 Ford F-350 Dually?
- Q&A: Replacement Mounting Brackets For HappiJac Electric Truck Camper Jack System
- Q&A: Looking for Dually Front Hitch
- Q&A: Can I Use Both the TorkLift StableLoad and the SuperSprings Super Sway Stops for Hauling Camper?
- Q&A: Do I Need Front Timbrens on a 2022 Ford F-350 Pulling a 5th Wheel Trailer?
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Maintenance Schedule
- Article: Stability Control for Heavy Duty Vehicles
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop