How are the Steel and Diamond Plate Trailer Fenders Measured

Updated 03/02/2010 | Published 03/01/2010

Question:

When measring your Steel and/or Diamond Plate trailer fenders . Are they measured from tip to tip over the top of the fender or end to end across the diameter

asked by: Jeff

Expert Reply:

When measuring our Steel and Diamond Plate trailer fenders we measure overall width, overall length across the diameter of the fender (across the bottom where it would set on the floor) and overall height. So the 16-Gauge Steel, Single-Axle Trailer Fender, item # HP36VR, is 9 inches overall width, 32 inches overall width across the bottom and 15 inches overall height. All of our fenders are measured in the same way. The video shows how this is measured at the very end.

expert reply by: Robert G