Weld on a heavy-duty tie-down point where your load sits, not where the trailer came with loops. The curved D-ring gives hooks and straps more room to seat, so you can cinch down hard without fighting a flat ring.
If you're hooking up wherever you can, you end up with off-angle pulls that twist hooks, shift the tie-down path, and make you reposition straps just to get the load settled. Welding this D-ring assembly onto your trailer lets you create a dedicated anchor point where your cargo sits, so your tie-downs start from a better line instead of fighting the layout you already have.
The included weld-on clip gives you a dedicated mounting point for the D-ring once installed. That means you can add tie-down points to match your load style, whether you're securing equipment, materials, or bulky gear that never seems to land near the factory tie-downs.
This D-ring has a bend instead of a flat ring, which helps hooks and strap hardware seat more naturally on the anchor point. That extra clearance can help when you're reaching in tight spots or when your tie-down angle makes a flat ring feel cramped.
This assembly is stored with oil to help keep rust from forming during storage so the steel stays clean for welding. It's left unfinished from the factory because most installs are welded and then finished by you, which also means you are not stripping paint or powder coat before you start.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everybody, Andy here with etrailer. Let's take a quick look at this etrailer Forged Steel Curved D-Ring Tiedown Anchor with Weld on Clip. Now this is a heavy duty D-ring tiedown anchor that's designed for serious hauling. This is rated with a 15,600 pound working load limit. So this is built to handle large equipment, flatbeds, and trailers that regularly carry heavy loads. And with a braking strength of 46,800 pounds, there's a solid safety margin behind this.
Now, one thing that makes this D-ring stand out is the curve design, as you can see here. This has a 55 degree angle, so instead of being flat, it does have that slight bend, which is gonna help your hooks and straps sit more naturally in the ring. That means less awkward angles and better contact when you're securing your load. Let's go over some measurements here. So looking at what I'm calling the outer width, pretty close to five inches.
The outer length or height, pretty close to five and a half inches. And then the internal width right at about two and seven-eighth inches. And then the internal length or height, about three and three-eighths inches. The thickness of this ring is one inch and that is stamped here as well. We do have that working low limit stamped of 15,600 pounds, but this is made from forged steel, so it's gonna hold up better over time compared to standard steel.
It's gonna resist bending and wear even with repeated use and heavy tension. Another key point to make is that this does come oil coated and unfinished. That's gonna keep it protected from rust while in storage. Again, as I mentioned, the clip is included with this to weld this into place, so it's made ready to weld right onto your trailer or equipment without a lot of extra prep. Now one final thing that I wanna mention is if you want help getting this installed, getting it welded into place, on this product page underneath the photo section, we do have a link that will take you to our installer locator.
Click that link and answer the questions that it has for you and that locator will find an installer that etrailer has partnered with in your area to do the installation for you. That's gonna wrap up our look today. I do hope that it was helpful for you. Again, my name's Andy. Thank you for joining me.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.



Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.