Mounting Tab Dimensions For Bulldog High-Profile Latch On Collar-Lok Coupler

Question

Question:

on the bulldog high profile coupler what size does the mounting tab for the latch need to be

asked by: Brad

0

Expert Reply:

I have attached a photo of the Bulldog Collar-Lok Coupler, part # BD028382 you can check out. The photo has the dimensions of the mounting tab that the # BD024200 latch repair kit is designed to work with. The mounting tab measures 2 inches wide and 2-3/8 inches tall. A 3/8 inch slot is cut in the material that is used for the pin clip that holds the latch assembly in position.

The material is .240 inches thick and is welded to the top of the coupler tube.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

Because Buyer's Products considers the build sheets and CAD drawings to be proprietary information, they won't provide copies of that. This being said, I pulled one of the #3370091560 Buyers Products couplers from stock and and measured the…

view full answer...

Answer 2

Yes, you can absolutely drill holes in your trailer tongue to install the 10,000 lb capacity Buyers Products Straight Tongue Trailer Coupler #3370091560. This is a pretty common occurrence due to the various bolt hole patterns of straight tongue…

view full answer...

Answer 3

The two couplers you referenced are identical size-wise. The #DM15000-52 is a bolt-on application with the EZ latch system and a silver finish. The DM12563 uses a standard latch, is a weld-on application and has a red finish. For the #DM15000-52, the…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

Hey Donna, yes the Replacement Grease Cap for Dexter/Tie Down Engineering Vortex Trailer Hubs #DE69NR that you referenced does work as a replacement for your Dexter 21-261 cap. How do you like the Vortex trailer hubs?

view full answer...

Answer 7

Hello James, thanks for reaching out. Both the kits you mentioned, the Hydrastar #HYD22FR and #HYD42FR are complete conversion kits for standard 3,500 lb axles. The difference is the calipers included with each kit. The #HYD22FR has stainless steel…

view full answer...

Answer 8

Welcome back Gary. To replace a 2" coupler that fits a 2" wide trailer tongue our options are limited to the Channel Tongue Trailer Coupler item #CT-3001-Z. It's got the standard trigger latch. There's not many options for couplers…

view full answer...

Answer 9

The channel of the Demco 21K #DM16080-52 coupler is 3 inches deep. The distance from the center of where the trailer ball would sit to the first 5/8 inch hole is 7 inches, and 12 inches to the second hole. The Titan #T4853100 dimensions are a little…

view full answer...

Answer 10

Hey Brian! Yes, the Firestone Ride-Rite Air Helper Springs #F89VV will fit your 2025 Toyota Tundra. That is just the generic picture attached to that page, I can see how it would be confusing. These are designed to mount over the axle, and are…

view full answer...

Mounting Tab Dimensions For Bulldog High-Profile Latch On Collar-Lok Coupler

Continue Researching