Does the Grease Cap # RG04-040 Have a Zerk Fitting
Published 09/23/2014
Products Featured in This Question
Question:
I cannot determine whether this grease cap has a grease zirt? Does it?
asked by: Ron
0
Expert Reply:
The Grease Cap # RG04-040 that you referenced does not have a zerk fitting. It is designed for use on EZ lube axles that have zerk fittings on the end of the spindle. This cap has a rubber cap to allow for easy access to that fitting.
You may be looking for a Bearing Buddy as those do have the zerk fitting. For a bearing buddy of the same size as the # RG04-040 you would want the part # BB1980A-SS.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Grease Cap, 1.99" OD EZ Lube Drive in with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- EZ Lube Grease Cap
- 1.99 Inch O.D.
- 1.99 Inch
- 2000 lbs Axle
- 2200 lbs Axle
- 2500 lbs Axle
- 3000 lbs Axle
- 3500 lbs Axle
- TruRyde
more information >
Continue Researching
- Q&A: What do All the Numbers on My Grease Seal Mean? What Numbers are Important?
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: How Are The Dexter Vault Bearing Protectors Measured?
- Q&A: Availability of USA Made Bearing Kit for 3,500 lb Trailer Axle
- Q&A: Looking for Bearing Kit for 3,500 lb Trailer Axle
- Q&A: Looking For Pre-Grease Hub Assembly For 2008 Bear Trailer
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: 7 Common Questions Everyone Has About Trailer Tires