32 inch Long Trailer Fender that Can be Bolted On
Published 08/22/2014
Products Featured in This Question
Question:
Is the lip that mounts to the trailer wide enough to drill and bolt on
asked by: Willard
0
Expert Reply:
I have a better solution for you, for a fender that would be easier to drill and bolt on than the # HP29VR that you referenced I would recommend the # HP36VR as this fender is the same size as the one you referenced except it has a flat back on it without a radiused lip that would make drilling and bolting much easier.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Single Axle Trailer Fender for Enclosed Trailers - Cold Rolled Steel - 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 15 Inch Wheels
- 10-3/4 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Q&A: How To Bolt-On, Weld On Trailer Fenders
- Q&A: Can I Wire 2 of the Atlas IV Vaquero Self-Contained Hydraulic Trailer Jacks Together?
- Q&A: Replacement Master Cylinder For Titan Model 60 W/ 23361 Master Cylinder
- Q&A: Is it Okay to Tow a Trailer without Fenders
- Q&A: What is the Difference Between Curt and Towsmart Hitches for a 2025 Kia Sportage
- Q&A: What is the Difference in the MORryde Hand Rail?
- Q&A: Availability of Replacement Grease Seal 450133
- Article: Most Popular Wheel Bearings
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hitch Mounted Cargo Carrier Information
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Best Bike Racks for Electric Bikes