Replacement LED Availability of the LED Heavy Duty Trailer License Plate Light # LPL41CB
Updated 08/18/2014 | Published 08/17/2014
Products Featured in This Question
Question:
I have a brand new ranger boat and the trailer has this light. The light is burned out. can I replace a bulb, if so how, what is the part number for the bulb? if not, then I need to replace the entire light?
asked by: Trace
Expert Reply:
I checked with Optronics and there isn't a replacement LED available for the LED Heavy Duty Trailer License Plate Light # LPL41CB. You would need to replace the entire unit. Which when you consider that most replacement LEDs are more expensive than this whole unit it's not a bad deal just replacing the whole thing.
If you had the incandescent bulb version of this light you could replace the bulb with a # A194B.
Product Page this Question was Asked From
Optronics LED Trailer License Plate Light - 5 Diodes - Chrome Plated - Clear Lens
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4L x 1-3/4W Inch
- White
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Replacement for a Tie Down 70lc Brake Actuator
- Q&A: Axle Hub That Uses Bearings JM511946 and JM205149, Race JM511910 and JM205110
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting EOH Brakes With Hydrastar Actuator Not Working With 2024 Ford F-450
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: How Much Do the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches Weigh?
- Q&A: Replacement Actuator For Older Tie Down 70LC
- Q&A: Replacement Hub and Brake Assembly for AL-KO 8490
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Replace or Install an RV Roof Vent
- Article: Double-Eye Trailer Suspension System Review
- Article: 7 Common Questions Everyone Has About Trailer Tires