Using an Optronics LED Light as a Side Marker and Turn Signal Without Brake Lights
Updated 11/07/2026 | Published 11/06/2026 >
Products Featured in This Question
Question:
Can this light be wired to function as a side marker that flashes with the turn signal but does not function as a brake light?
asked by: Chris
Expert Reply:
Hey Chris, welcome back! You can use the Optronics LED Trailer Light # STL12RCB as a standard marker light with the Right Angle Pigtail # A47PB. Just connect the black wire for the running lights, ground the white wire, and cap off the red wire.
If you want it to flash with your turn signals without activating with the brakes, you'll need a 2-to-3 wire converter like the Curt # C56196 to separate those signals. Curt doesn't list it as LED compatible, although some customers have successfully used it with LED lights. I can't guarantee it will work with your setup, but it is an option.
What kind of trailer are you installing these on?
Product Page this Question was Asked From
Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 6 Diodes - Oval - Clear Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2-1/4W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: GE Appliances RV Refrigerator with Top Freezer - 9.8 Cu. Ft. - 12V - Black - Right Opening Door
- Shop: Replacement Lower Sidewall Vent for Dometic Americana II RV Refrigerator - Polar White
- Q&A: Will Replacement Center Cap for 16" Aluminum Viking Series Wheels Fit Other 16" Wheels
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Article: Trailer Wiring Diagrams
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: Recommended Replacement Converter for a Elixir ELX-45
- Q&A: Fifth Wheel Hitch to Gooseneck Adapter Compatible with Lippert Rota Flex Pin Box
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Upgrading Weight Distribution Bars For Heavier Trailer On Blue Ox TrackPro Weight Distribution
- Q&A: How To Re-Assemble The RAM TJD-12000SP Trailer Jack
- Article: Best Ladder Racks
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)



Chris
11/7/2026
They're for a custom aluminum storage bumper that will protrude about 15 inches from the rear of my camper van. Adding lights to improve visibility. Side repeaters would be nice, but I don't want brake lights on the sides, of course.