etrailer Electric Jack # e55ZV Making Grinding Noise During Operation
Updated 10/01/2026 | Published 09/30/2026 >
Products Featured in This Question
Question:
I purchased a e55ZV etrailer Electric Trailer Jack - Leg - A-Frame - 18 Lift - 5,000 lbs back in June 2026, the issue is that when putting a load on extending the jack it sounds like a grinding or crunching noise, it still works, but sounds bad. Just wondering is this normal?
asked by: Ronald F
Expert Reply:
Hey Ronald.
I looked into this for you and found that it's definitely not normal. However, there are some reasons this could be happening. I recommend confirming that the jack tube is straight and not being side loaded. Make sure the battery is fully charged, and you have clean connections for your positive and ground. Lastly, just take note of when this is occurring; the whole time or only at full extension/retraction. But there is a good chance this is the start of an internal gear or drive screw failure. This product # e55ZV has a 2-year warranty so a claim would be fitting if the connections and mounting look good.
Just let me know if you find that everything is working normally and do indeed need a new one.
Product Page this Question was Asked From
etrailer Rubber Hitch Cover for 2" Trailer Hitches - Qty 1
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does Curt Hitch for 2026 Toyota Corolla Cross Also Fit Hybrid Models
- Q&A: What's The Difference Between the etrailer and Demco Baseplate 2025 Jeep Wrangler
- Q&A: Best Trailer Hitch And Wiring Harness For 2026 Nissan Rogue Dark Armor Edition
- Q&A: Replacement For 7-Way Socket That Came With ETBC7/ETBC7L Kit
- Q&A: Recommended Hitch for a 2026 Toyota Corolla Cross and How to Install It
- Q&A: Recommended Base Plate that Works With a 2024 Jeep Wrangler
- Q&A: Will the Demco Excali-bar 9511006 Work With the Demco Tabless Kit On Jeep Wrangler Unlimited
- Article: Which Hitches are Made in the USA
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How to Measure for Trailer Hitch Drop
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)


Ronald F.
10/1/2026
Trent, I have check all the connections, battery, and the jack tube, all are good. The noise comes when I am lifting the trailer while attached to the truck to add the WDH bars. My camper is a 2205S Mini Lite. RF