Torklift Frame Mounted Camper Tie Downs that Fit 2024 Ram 3500 Megacab
Updated 09/21/2026 | Published 09/14/2026
Question:
Hi! We have a Lance 825 truck camper on a Silverado 2500 short bed and are looking to upgrade our truck to a Ram 3500 Megacab DRW. I want to make sure there are camper tiedowns that can be added to the Megacab before making any decisions. Are there tiedowns for Megacabs? Not seeing a lot online about campers on Megacabs. Any info would be appreciated.
asked by: Mark D
Expert Reply:
Hey Mark, there aren't any fit exclusions for the megacab versions of your 2024 Ram 3500 for Torklift camper tie downs. So the part # TL75FV that you referenced is a confirmed fit and will work great! Do you have turnbuckles already?
Product Page this Question was Asked From
TorkLift Tie Downs - Custom Frame Mount - Front and Rear
- Truck Camper Tie Downs
- Front Tie-Downs
- Frame-Mounted
- Custom Fit
- Powder Coated Steel
- TorkLift
more information >
Continue Researching
- Q&A: TorkLift Camper Tie Downs For 2024 Ram 3500 Crew Cab Long Bed
- Q&A: Looking for Torklift Camper Tie Down for 2024 Ram 3500
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Availability of Front TorkLift Tie-Downs From TL75FV For 2020 Ram 3500
- Q&A: How to Replace a Lance 6-Pin Plug w/a Standard 7-Way Connector
- Q&A: Do I Need the TorkLift Camper Anchor Relocation Kit w/ a 2022 Ram 3500 8' Bed Dually?
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Mount a Truck Bed Camper
- Article: Stability Control for Heavy Duty Vehicles
- Article: Must-Have Flat Towing Components
- Article: Blue Ox Vehicle-Specific Base Plates
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
Rick
9/18/2026
I've put these mounts on two different 3500 Rams. Never mega cab, they are pretty simple they attach to the rear cab mount the tricky part is the bolt that goes in the frame. I found after dropping one in the frame. If you put a pair of needle nose, vice grips on the bolt. While you're putting the mount and the nut on, you won't drop it in the frame rail. The other hard part is emergency brake cable it takes a super deep socket or a lot of patients in a wrench. On a mega cab, I think the thing that I would pay close attention to is where the running boards end. If they go all the way to the back of the cab, the tie down will hit the running board and you won't be able to use them.