How Do The Custer LED Side Marker or Clearance Trailer Lights Install?
Updated 08/28/2026 | Published 08/22/2026
Question:
I purchased clearance lights CPL120A. The question I have is are they mounted from the rear or is the outer front lens removeable allowing screws to be installed from the front. I tried to remove the front lens cover but I dont want to damage the light!
asked by: Gordon B
Expert Reply:
Hey Gordon, thanks for reaching out. Yes, the amber lens on the Custer LED Side Marker/Clearance Light # CPL120A pops off to access the mounting holes. The lens is a snap-in design, so there are no screws holding the lens itself in place.
To remove it, I recommend using a small flat-blade screwdriver or plastic trim tool at the seam between the amber lens and the black housing. Gently work along the edge and pry outward until the retaining tabs release. I would work around the perimeter rather than putting a lot of pressure in one spot, especially if the light is cold, since the polycarbonate gets less flexible.
Once the lens pops off, you will have access to the two mounting holes spaced 3" on center. After installing the screws, line the lens back up with the housing and press around the edges until the tabs snap back into place.
What kind of trailer are you mounting them on?
(click to enlarge)
Product Page this Question was Asked From
Custer LED Side Marker or Clearance Trailer Light - Submersible - 16 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 4L x 2W Inch
- Amber
- Custer
more information >
Continue Researching
- Shop: Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Shop: Hydraulic Trailer Brake - Uni-Servo - Free Backing - Dacromet - 10" - Right Hand - 3,500 lbs
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Q&A: Help Understanding and Achieving the 21K Weight Capacity of Demco Trailer Coupler # DM14040-81
- Q&A: Disc Brake Kit Recommendation for 3,500 lb Axle and 5 on 4-1/2" Bolt Pattern Idler Hub
- Q&A: Replacement Drum Surge Brake Actuator for a TDE Model LP7000
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: How To Add a Trailer Brake Controller To Old Monaco Motorhome
- Q&A: Can a Brake Controller be Installed on a 2000 Monaco Dynasty with Exhaust Brake
- Q&A: Replacement RV Step Motor for Part Number 300-1406
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Trailer Tire Sizing
- Article: Basics of Tie Down Straps
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
Gordon B.
8/27/2026
Thank you for replying to my question Jessie. I did finally get the outer cover off but it fits extremely tight ( which is good ) but I was afraid of breaking the lens. All Is Good Thanks Again!!!!