Can Gen-y Phantom be Used as Hi Lo Adapter
Updated 08/20/2026 | Published 08/13/2026 >
Question:
Can this be used as a hi-lo adapter by leaving out the ball platform? I need to lower my cargo tray to open my van doors but I dont want the tray sitting an additional 6inch behind the vehicle as with other adapters.
asked by: Sharon
0
Expert Reply:
Hey Sharon, yes you could use the Gen-Y Phantom Ball Mount part # GY37WR as a high low adapter if you needed to. You could remove the ball mount platform and use the openings as basically an additional hitch opening like you are wanting to do.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Gen-Y Phantom Hitch Ball Mount - 2" Hitch - 5K - 4.5" Drop
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- No Ball
- Steel Shank
- Drop - 4 Inch
- Rise - 4 Inch
- Fits 2 Inch Hitch
- 5000 lbs GTW
- Gen-Y Hitch
more information >
Continue Researching
- Q&A: Shock Absorbing and Adjustable Ball Mount for a Cruisemaster DO35 Coupler
- Q&A: Cushioned Ball Mount for DO35 Hitch on Off-Road Travel Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended 6 Drop Adjustable Ball Mount with 7,500 Lb Capacity
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Alternative Solution for Towing a Casita Trailer with a 2024 Honda Ridgeline
- Q&A: What is the Trailer Tire Metric Equivalent to a 4.80 x 12 Trailer Tire
- Q&A: Can Kuat Piston Pro X Bike Rack Be Used at Rear of Flat Towed Vehicle
- Q&A: How Much Does The BulletProof Hitches Aluminum Adjustable 2-Ball Mount - 2-1/2" Hitch Weigh?
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)



Mark H.
8/20/2026
I used the hitch for a hi and low mount on the back of my RV to mount a e-bike bike rack above the tow bar for my towed car. I did not use the included ball since both the bike rack and tow bar for the vehicle fit into the 2” receivers on the Gen-Y phantom. I really like the fact that it keeps the bike rack closer to the RV to help minimize bounce effect of the bikes compared to other mounts.