Troubleshooting no Running Lights on a Trailer Towed by 1996 Ford Ranger
Updated 07/22/2014 | Published 07/20/2014 >
Question:
Cant figure out where disconnect is. Blew up2 elevtrical checkers. Also checked fuses.
asked by: Dank
Expert Reply:
The first thing I would check is the running light circuit on the truck side trailer connector to make sure a signal is getting through. Using a circuit tester like # 3808, and test the pin next to the covered ground pin. If the signal is getting through for the running lights then you know the problem is on the trailer side. if it is not, then you know the problem is on the truck side.
You can also check for any broken or loose connection along the wiring to the trailer connector. Finally, make sure the ground is connected to a clean and corrosion free bare metal surface.
If the problem is on the trailer side you can start by checking for and cleaning out any dirt or corrosion in the trailer side connector. Next, move on to checking the main ground from the plug. It should be attached to a clean and corrosion free bare metal surface on the trailer frame. You can also check to verify that the pin on the trailer side for the tail lights matches up with the pin for running lights on the truck.
Next, you can check the grounds at each of the lights. Trailer lights usually ground through the mounting studs and they should be attached to a clean and corrosion free bare metal surface. If the trailer has extra running lights, it may be too much of a power draw on the system and this could cause the lights not to work. You will need to either remove some clearance lights or replace them with LED versions if this is the case.
Product Page this Question was Asked From
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Difference Between A35WB And A35W42B 35 ft. Wishbone 4-Way Trailer Wiring Harness
- Q&A: What Wire Gauge Is The TowSmart 16 to 18 Gauge, 4 Conductor Wire?
- Q&A: Recommended Bolt On 7,000 lbs Capacity Square Jack
- Q&A: Can A No-Drill Bracket Be Installed On A Hitch With A Square Crosstube?
- Q&A: Which Grease Seal would Fit Dexter 7k Trailer Axle
- Article: Trailer Lighting Requirements
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Article: How to Measure Your Trailer Wheel Bolt Pattern



