Can Furrion 7-Way Vehicle Power Adapter Be Installed Underneath Truck Bed
Updated 06/17/2026 | Published 06/13/2026
Products Featured in This Question
Question:
After purchasing a 2025 Silverado I discovered an issue that the 2014 did not have. Looks like I need the Furrion 7-Way Vehicle Power Adapter for 2025 Silverado for Furrion Camera system to work. Is it possible to locate the adapter where the existing one is? It looks like I should be able to move the original adapter to the underside of the bed and install the new adapter to the bumper, so that it is not just hanging there. Suggestions?
asked by: Ron T
Expert Reply:
Hey Ron! The 7-Way Vehicle Power Adapter # FR87PR will have to plug into the 7-way and hang off at the rear. The connections underneath your truck for the 7-way are USCAR which is different than the 7-way itself at the bumper.
If you would rather not have this hanging off the truck, I would consider hard wiring the 12V PWM Filter for RV Backup Camera Systems # VGR64VR on the trailer side. This does the same thing and completely eliminates the need for an additional adapter.
What kind of trailer are you towing?
(click to enlarge)
Bob H.
6/17/2026
Ron. I installed the filter on my 2019 escape trailer on the power line just inside the wall of the trailer behind the camera. The seven pin trailer connector and 2024 Silverado 1500 7 pin receiver worked just fine with this setup. I still think Furrion should be including this filter with the camera but it is what it is. Works great!!
Product Page this Question was Asked From
12V PWM Filter for RV Backup Camera Systems - Hardwire
- Accessories and Parts
- Backup Camera
- RV Camera System
- Cables and Cords
- Power Line Filter
- Voyager
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: No Signal And PWM Fix For Furrion Vision S Camera System Connected To 2022 GMC
- Q&A: Furrion Camera Has Power but Won't Pair
- Q&A: Will 12V PWM Filter Fix Power Loss On Furrion Camera With 2026 Chevy Silverado 2500 Trail Boss Z71
- Q&A: Troubleshooting A Furrion Vision S RV Camera System That Fades In And Out Of Pairing
- Q&A: Will Voyager 12V PWM Filter Allow Furrion Vision S to Work With 2025 GMC Sierra Denali
- Q&A: How Many 12V PWM Filters is Needed on a Multi Cam Furrion Vision S System
- Q&A: Troubleshooting Non-Working Sidemarker Cameras Of A Furrion Vision S RV Camera System
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: How to Raise Your Travel Trailer Height
- Article: How to Mount a Truck Bed Camper
- Article: RV Pre-Departure Checklist
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
David D.
6/17/2026
Hi Ron, I used the PWM filter right in the housing of the backup camera on a cougar. It’s a little tight but it fits and works well. That way I didn’t have to alter the 7 way connection in the bed of the truck for my fifth wheel. Just a suggestion, four bucks more but in my opinion, well worth it.