Looking For Replacement V-Roller For Boat Trailer
Updated 05/22/2026 | Published 05/17/2026
Products Featured in This Question
Question:
I am looking for a replacement roller for my boat trailer. There are three parts to the roller a center piece that is 9inches long, about 4 inches in diameter at the ends and tapers to about 2 inches in diameter in the middle. Then there are two donut like rollers on either end that are about 4 in diameter and about 1 inch wide. I have pictures, but do not see how to attach them to this inquiry. Thanks!
asked by: Donald N
Expert Reply:
Hey Donald, thanks for reaching out. We do have keel rollers that are similar to what you are describing. Looking thru the V-rollers we carry its looking like the CE Smith Deep V Keel Roller Assembly # CE10404G is pretty similar. The roller itself is 9-1/4" long, but it does not have any additional "donut" pieces on the end. We don't have anything that has those additional pieces so it could be in your case someone pieced something together. We do have longer rollers like part # CE10455G (12" long) if you need something longer. I'm thinking these will be your best bet.
There is no way to add pictures to the comments on here, but if you'd like to email pictures to me I'm happy to take a look. My email is [email protected].
(click to enlarge)
Product Page this Question was Asked From
CE Smith Deep V Keel Roller Assembly for Boat Trailers - Galvanized Steel/Black Rubber - 10"
- Boat Trailer Parts
- Rollers
- Keel Roller
- Rubber
- 10 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Article: Trailer Tire Sizing
- Q&A: How to Determine if a Torsion Axle Needs to be Replaced and Lifting a Trailer Off the Ground
- Q&A: How to Attach Fulton F2 Trailer Jack to Frame that is 6 inches Tall
- Q&A: Jack Recommendation for a 6 inch Tall Trailer Frame
- Q&A: Swivel Mount Trailer Jack for 6 Inch Tall Trailer Frame
- Q&A: Recommended Solution to Re-Wire 4 Way Trailer Plug with 8 Wires
- Q&A: 10 Inch Black Rubber Keel Roller for a 1/2 Inch Shaft
- Article: What Size of Boat Trailer do I Need?
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: The Basics of Boat Trailer Bunks: Bunks or Rollers?
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Tell the Weight Rating of a Trailer Axle
Donald N.
5/21/2026
My trailer has mounts so I would not need the metal part of this item, is the roller available by itself without the metal bracket? Thanks!