Replacement Drop Leg for the etrailer Boat Trailer Jack w/ Footplate MJSQ-2500B

Question

Question:

can you get parts for this one

asked by: Tom R

0

Expert Reply:

Hey Tom. The only replacement part I have for the etrailer Boat Trailer Jack w/ Footplate item # MJSQ-2500B is the drop leg item # TJD-5000-FT. The drop leg that comes with this jack is 1-3/4" square which is the same as item # TJD-5000-FT. It also has the same hole spacing.

What replacement parts are you looking for and what problems are you having with your jack?

You can add this information, along with any other questions you have, where it says Add Comment.

expert reply by: Jerred H

0

TJD-5000-FT
(click to enlarge)

Answer 1

The Grease Seal #168233 is the correct seal to replace the AD2527. Your seal is an older design that wasn't the greatest hence the reason you don't see it around anymore. The new seal is a double lip seal that make it right for your boat…

view full answer...

Answer 2

The only difference between single and dual servo hydraulic drum brakes is that dual servo will provide more force while in reverse than single servo. That said, it's not much and most really don't use their brakes a ton in reverse so single…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Replacement Drop Leg for the etrailer Boat Trailer Jack w/ Footplate MJSQ-2500B

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching