Could SnapPad Mini part # SN39FR Fit 2024 StarCraft Super Lite

Question

Question:

Will these fit that stabilizer feet on a 2024 StarCraft Super Lite?

asked by: Cass W

0

Expert Reply:

Hey Cass, can you measure the feet of your 2024 StarCraft Super Lite? The SnapPad Mini Jack Pads for Travel Trailers w/ BAL - 5-1/2" Square Jack Feet # SN39FR is designed to fit 5-1/2 inch square feet which might be what you have but I don't have a way to verify that. Let me know what you have and I'll get you what you'd need.

expert reply by: Jameson C

0

Cass

4/26/2026

It looks like my stabilizer feet are just under 6 inches, not by much and they have a tiny curve on each of the four sides as well?

Jameson C.

4/27/2026

@Cass If it's a 6 inch square pad the correct Snappads would be the part # SN99FR.

Answer 1

Hey Mike, welcome back! I went ahead and sent this off to SnapPad to see if they have any fitment information with the Ultra-Fab Power Twin II #UF39-941705. I don't have the Ultra-Fab in the warehouse right now to try and test fit, and there is…

view full answer...

Answer 2

Hey Tom, great question! Both products provide an easy way to measure tongue weight, but they excel in different situations. The BTBRV Trailer Jack Foot Scale #BTBRV014 measures tongue weight at the trailer jack, so you don't need to position a…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Could SnapPad Mini part # SN39FR Fit 2024 StarCraft Super Lite

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching