Wiring Diagram for the Bulldog Powered-Drive Kit # BD1824200100
Question:
Can I mount the unit on the left side? It would be better because of the spare tire on the right side. The picture shows it on the left. IN that case, I would believe the black would become the positive for the switch. Please advise about how to wire using the terminal box. I dont understand what wires go where?
asked by: Harvey S
0
Expert Reply:
I spoke to my contact at Bulldog and he informed me that the Bulldog Powered Drive Kit part # BD1824200100 that you referenced can only be installed on the driver side of the trailer due to how the gears of the jack setup.
To see how it all wires up check out the wiring diagram I attached that I took from the installation instructions for this kit.
click to enlarge
expert reply by: Jameson C
0
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Electric Motor
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Similar Expert Q&A Pages
- Replacement Parts for Bulldog Powered-Drive Kit for 12,000 Pound Bulldog Trailer Jacks
- Distance From Center of Shaft Down to Bottom of Bulldog Powered Drive Kit BD1824200100
- Installation of Bulldog Powered-Drive Kit for Single-Speed Jacks # BD1824200100 on a Trailer
- What Are the Dimensions of Bulldog Powered-Drive Kit for Single Speed Jacks
- Could Bulldog Powered-Drive Kit Possibly Fit 2006 Millennium 36 ft Gooseneck Trailer
- Are There Replacement Parts for the Bulldog Powered-Drive Kit for Single-Speed Jacks
- Recommended Power Supply for Bulldog Electric Single Speed Jack # BD1824200100 Used on Horse Trailer
- Amperage Draw of Bulldog Powered-Drive Kit
- Will Bulldog Powered-Drive Kit Work With Bulldog Square Jack
- Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Correct Replacement Motor for a Bulldog 12K Jack
- Can the Bulldog Powered-Drive Kit be Used on Any Jack
- Replacement Switch For Bulldog Powered-Drive Kit on Single-Speed Jacks with 12,000-lb Capacity
- How to Tell if a Bulldog 10K/12K Jack is a Single Speed or 2-Speed
- Gear, Bushing, & Spring Replacement Kit For Jacks Manufactured Before 2003
- Troubleshooting Bulldog Electric Landing Gear that Turns But Does Not Raise or Lower Jack
- Available Electric Motors to Convert Landing Gear to Motorized Operation
- Electric Landing Gear Legs for a 2017 Sundowner 3H GN Super Sport Horse Trailer
- Capacity of Bulldog BD1824200100 Powered Trailer Jack Drive Kit
- Can Bulldog Powered Drive Kit for Landing Gear be Used on Gooseneck Trailer with 8,000 Pounds On It
- Bulldog Powered-Drive Kit No Longer Responds To Remote
- Powered Landing Gear Recommendation to Replace a Ram Trailer Jack
- Where Does Ground of Bulldog Powered-Drive Kit for Single-Speed Jacks # BD1824200100 Go To
- Will the Bulldog Powered-Drive Kit Work On RAM 12K Jacks
- Replacement Jacks and Electric Motor To Upgrade a 1999 Sooner Horse Trailer
- Wire Loom to Use With Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Powered Drive Kit Recommendation for 2 Speed Bulldog Landing Gear
- Will the Bulldog Powered Drive Kit for Single Speed Jacks fit a 10K Jack