Looking for Blind Spot Warning System that Could Work on 40 Foot Motorhome

Question

Question:

Do you sell a Blind Spot Warning System the would work on a 40 motorhome that also tows a Ford Bronco for a total length of 60?

asked by: Tom M

0

Expert Reply:

Hey Tom, we have the Blind Spot Monitoring System # CU95XR which is designed for setups that are up to 40 feet long. Since your motorhome is that length it would work for it. Were you also wanting a way to connect sensors on the towed vehicle as well?

expert reply by: Jameson C

0

Tom M.

1/21/2026

I was hoping to have one system mounted on the motorhome that covered the entire 60' length of the motorhome and towing vehicle.

Jameson C.

1/21/2026

@TomM I see what you mean. I wish we had something but that's not a kit we offer.

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hey Brian, the Blind Spot Monitoring System for Towable Campers, Travel Trailers, and 5th Wheels Up to 30' Long #CU65XR that you referenced can give you a blind spot monitoring system but its not going to integrate into your vehicle wiring. It is…

view full answer...

Answer 6

Hey Steve, good question. Technically yes it would be possible to install the Blind Spot Monitoring System #CU65XR on a car or SUV. It comes with a 30' harness so you would have a lot of extra camera wires to deal with. Also you would need to…

view full answer...

Answer 7

To replace your Parallax 7445 converter you can use the Progressive Dynamics 9200 Inteli-Power Converter #PD9245C. This has the same amperage so you can just reuse the wiring running from the converter to the battery bank. The Parallax 7445 should…

view full answer...

Answer 8

The overall height of the Timbren Rear Suspension Enhancement System #TDRTT1500 that you referenced is 4-9/16 inches with the included 1 inch spacer installed. Without the spacer it's 3-9/16 inches. Timbren recommends you have between 1/2 inch to…

view full answer...

Answer 9

If you have a 2019 Ram 1500 that is the standard pick-up truck, the correct Timbren system is the Timbren Rear Suspension Enhancement System #TDR1500DQ, which were designed for standard trucks. The difference between these and the Timbren System…

view full answer...

Answer 10

For your 2020 Ram 1500 you will want to go with the Timbren Rear Suspension Enhancement System #TDR1500DQ as the Timbren Rear Suspension Enhancement System #TDRTT1500 are a severe service kit which are designed for trucks that constantly have a lot…

view full answer...

Answer 11

Hey Scott, since your 2018 Toyota Tundra Crewmax has a bed length of 5-1/2 feet the automatic slider fifth wheel hitch kit you would need would be the Demco Hijacker part #DM28XV which comes with the correct rail kit for your truck as well. This…

view full answer...

Looking for Blind Spot Warning System that Could Work on 40 Foot Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching