Will the Dexter Fortress Threaded Aluminum Oil Cap Fit with an 8-Lug 15K Axle?

Question

Question:

will these work with 8-lug 15K grease bath axles?

asked by: William S

0

Expert Reply:

Hey William, thanks for reaching out!

Yes, the Dexter Fortress Threaded Aluminum Oil Cap # DX27CR will work with 15K oil bath axles.

If you have a specific axle in mind, let me know what it is and I'd be happy to reach out to Dexter if you're wanting to double check on it.

expert reply by: Jon G

0

Jon G.

10/30/2025

Hey William, did the Dexter Fortress oil caps end up fitting your 15K grease bath axles the way you needed? Your update could make it easier for others working with similar heavy-duty setups.

Answer 1

You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…

view full answer...

Answer 2

To figure out the correct oil bath cap, you will need to know your axle's capacity or size of your hub bore. For a 3,500 lb hub or 1.98" hub bore you would use Kodiak XL ProLube Oil Bath Hub Body and Cap #XLPROLUBE1980, or for the kit you…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Will the Dexter Fortress Threaded Aluminum Oil Cap Fit with an 8-Lug 15K Axle?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching