Curt TruTrack Weight Distribution System Install - 2021 K-Z Connect Travel Trailer Video

Hey Bernard, the hitch ball that comes with the Equal-i-zer #EQ37140ET does not come pre-installed onto the head of the system.

The Tech at B&W says the hitch ball part #BWHB94004 should tightened to 120 ft lbs with a 2-15/16" wrench.

Do you see the white plastic piece in the shape of a U in the picture that you sent me? You will need to pull that piece out away from the harness to release it from the rest of the 7-way. Check out the video I attached and skip to the 3:25 mark to…

Most manufacturer's say 10% under your truck's capacity but our recommendation is to go between 20%-25% below. So you would want to go no higher then 1,992 lbs - 1,867 lbs of tongue weight with your 2020 Chevrolet Silverado 2500. I have…

To see installation details for both hitches, click the provided links. The Curt #C14011 installs using 18mm bolts that use existing nut plates in your Excursion's frame. No drilling is required to completed the installation. The hitch has a…

You will naturally be better off if your shop does NOT break off the factory weld nuts when removing the OEM hitch from the frame rails on your 2001 Excursion. Given the vehicle's age its quite likely that the bolts securing the OEM hitch will…

Trailer manufacturers list the loaded tongue weight for a trailer as being 10% of the loaded weight of the trailer, which is why you see 1,050 lbs for a GVWR of 10,500 lbs for your trailer. In reality you can make the tongue weight whatever you want…

I have good news! For the most part, weight distribution shanks are interchangeable between different manufacturers. For your existing Curt Weight Distribution System, I recommend changing to the Equal-i-zer Weight Distribution Shank #EQ90-02-4900.…

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…