Availability Of Plunger and Socket Door Holder With 3-1/4" Long Plunger
Updated 09/26/2025 | Published 04/27/2025
Products Featured in This Question
Question:
Wondering if you have Part Number: PLR64-66 with a 3-1/4” plunger rather than 2-1/4”. Thank you.
asked by: Anthony A
0
Expert Reply:
Hello Anthony, thanks for reaching out. We do not have one that measures exactly 3-1/4" but we do have a 3 incher and a 4-3/4" incher if you think that will work. Take a look at the following:
- Plunger and Socket Door Holder for RV or Enclosed Trailer - 3" Plunger - Zinc Plated Steel # 37210284
- Plunger and Socket Door Holder for RV or Enclosed Trailer - 4-3/4" Plunger - Zinc Plated Steel # 37210294
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 2-1/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- Straight
- 2-1/4 Inch Long
- 2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: What is The Proper Way To Measure A Trailer Fender?
- Q&A: Replacement Inner Tube For Gooseneck Trailer Coupler That Doesnt Use Through Pin
- Q&A: When do You Need a Breakaway Battery Charger and How Does it Function
- Q&A: What Inner Tube do You Have for My Bulldog Gooseneck Coupler that Doesn't Use Load-Bearing Pin?
- Q&A: Which Toilet Floor Flange for 3 Inch Hub
- Q&A: 2019 Ford F-250 Super Duty In-Bed 7-Way Socket Recommendation for Aluminum Truck Bed
- Q&A: Dimensions of Buyers Products Hook and Keeper for Enclosed Trailer Door # BP64FR
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Replace an RV Roof Vent Cover
- Article: Roof Rack Information
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What are the Common Types of Propane Fittings Used on RVs?
Jesse M.
9/26/2025
Hi Anthony, did you find a solution with the 3-inch or 4-3/4-inch plunger options? I’d like to know what worked for you so I can help others looking for similar solutions.