Could the MB Sturgis Propane Pigtail w/ Back Check Work on 100 lb Propane Tank

Question

Question:

Will it work on 100 pound tanks?

asked by: John D

0

Expert Reply:

Hey John, yes the MB Sturgis Propane Pigtail w/ Back Check # 100833-36 would work on a 100 lb propane tank.

expert reply by: Jameson C

0

Jameson C.

9/26/2025

Hey John, did the MB Sturgis Propane Pigtail work well with your 100 lb propane tank? I'm curious to know how it turned out for you, as it could help others with similar needs.

Answer 1

We do not have a technical drawing, however I did head out to our warehouse and measure the: -Single Momentary Reversing Switch #37213865 for you. The dimensions are as follows: -The overall width is 3/4", -The overall length is 1-7/16",…

view full answer...

Answer 2

Thank you for the picture of your Kedu HY60D switch, the Single Momentary Reversing Switch #37213865 has the same 4 prong connection on the back as your pictures. The cutout dimensions for this switch are 0.835" tall x 1.457" wide.

view full answer...

Answer 3

Hi Shawn; the JR Products Compact Automatic Changeover 2-Stage Propane Regulator #37207-31525 has 1/4" FIF inlets. Your typical 20 lb propane tank is Type 1 so you can use one of the following depending on the length you want to have: -MB…

view full answer...

Answer 4

The large port on your Extend a Stay, basically part #CAM59113, is a male 1 - 20 disposable cylinder connection. To hook your BBQ grille up using that fitting you can use part #204132-MBS which is an adapter to a Type 1 fitting. Then use a Type 1…

view full answer...

Answer 5

Hi Doug; we don't have a cover specific to those jacks but you can use the etrailer Protective Cover for Electric A-Frame Jacks #e27VV. This is a weatherproof cover with polyvinyl fabric construction and a drawstring to cinch around the bottom.…

view full answer...

Answer 6

Hey John! It looks like you already ordered the #37213865 a few days ago. This switch will be able to replace the one you already have since it is the same 260 series with the same specs. As long as you swap the wires over to the same connections on…

view full answer...

Answer 7

I would be happy to help, but unfortunately I have no way of determining which size propane line is installed on your 2020 Cherokee Wolf Pup 16FQ. The MB Sturgis Propane Pigtail #100833-36 you were looking at uses a 1/4" male inverted flare to…

view full answer...

Answer 8

The MB Sturgis Propane Pigtail - Stainless Overbraid - Type 1 x 1/4" Male Inverted Flare - 15" #100833-15 is an 1/4" inverted flare tip and your regulator requires a standard 1/4" NPT fitting. You just need a pigtail like Propane…

view full answer...

Answer 9

Hey Mike, the correct replacement power switch for your Ram EJ3550 is the part #EJ-3520-PSW.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Could the MB Sturgis Propane Pigtail w/ Back Check Work on 100 lb Propane Tank

Product Page this Question was Asked From

Continue Researching