Electric Stabilizer Jack for Airstream Bambi

Question

Question:

Im looking for stabilizer jack similar to Lippert or Ultra Fab but the frame width is 56 inches on my 16ft Airstream Bambi. I am particularly looking to stabilizing fore and aft movement so wide cross struts are important. thanks.

asked by: David E

0

Expert Reply:

Hi David; you can actually use the Ultra-Fab Power Twin II # UF39-941707 on your Airstream Bambi. This fits frames from 42" to 77" wide so your 56" measurement isn't a problem. Just make sure you have 24" along the frame to mount the brackets. If you need anything else don't hesitate to reply below.

expert reply by: Robin H

0

Ultra-Fab Power Twin II
(click to enlarge)

Ultra-Fab Power Twin II Bracket Measurement
(click to enlarge)

Robin H.

9/26/2025

Hi David, did the Ultra-Fab Power Twin II work out for stabilizing your Airstream Bambi? I'm asking because your experience could help others with similar needs.

Answer 1

The trailer mover I suggest for your 3500-lb Airstream Sport travel trailer is the Trailer Valet 5X model #STC-V211. This 2-speed chain-drive trailer mover simply clamps on to either side of your A-frame (no welding and no drilling) and it can handle…

view full answer...

Answer 2

The ARK #ARK94FR stabilizer jacks could work for you, but you'll likely find they're too tall. The jacks measure 30 inches tall when fully extended or 19-1/2 inches tall when fully retracted. The existing 400914-03 jacks on your Airstream…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 9

There aren't any plug-in adapters for your 2023 Nissan Pathfinder unfortunately, so you'd have to use the Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers #RED69FR that comes with the brake controller. You could also use…

view full answer...

Answer 10

Congrats on the new SUV Jeff! To tow a trailer with your new 2026 Nissan Pathfinder, you'll need the following parts: Hitch - etrailer Trailer Hitch item #e36ZV 4-Way Connector - Curt T-Connector Vehicle Wiring Harness item #C95ZV 7-Way Connector…

view full answer...

Answer 11

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 12

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Electric Stabilizer Jack for Airstream Bambi

Featured Help Information

Miscellaneous Media

Continue Researching