Is There Tonneau Cover that Fits 2025 Ram Power Tailgate

Question

Question:

Does the pace Edwards ultra groove work with a 2025 ram 1500 Laramie with the power tailgate?

asked by: Dennis S

0

Expert Reply:

Hey Dennis, thanks to the feedback you provided we do know that the Pace Edwards UltraGroove # 311-KMDA24A55 will work on your 2025 Ram 1500 that has the power tailgate but you will need to move the rails slightly forward.

expert reply by: Jameson C

0

Dennis S.

4/18/2025

Jameson, Thanks for the response and also I called pace Edward’s before you responded and they stated that they have tested it on the 2025 ram with power tailgate and found that you might have to move the rails slightly forward towards the cab to take the pressure off when the tailgate is raised. Just fyi for you

Jameson C.

4/21/2025

@DennisS Oh nice! So they said it could fit then technically?

Dennis S.

4/22/2025

@JamesonC yes that’s what the customer service rep said they have a 25 1500 for testing their bed covers and just moving the rails forward slightly it works fine.

Jameson C.

4/22/2025

@DennisS Awesome, thanks for passing that on. Did you order one yet?

Answer 1

It sounds like you have a 2020 Ram 1500 with a 5-1/2 ft bed. The Pace Edwards UltraGroove Retractable Hard Tonneau Cover part #311-KRDA24A55 will work well if your multi-function tailgate as long as you don't have the RamBox. I contacted Pace…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Hey Joseph, thanks for reaching out. The difference between the yellow and black SumoSprings is the weight capacity or stiffness of the spring. For the 2018 Ram ProMaster 1500, the black ones part #SSR-307-47 are 1,500 lb capacity. Those are good for…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Is There Tonneau Cover that Fits 2025 Ram Power Tailgate

Product Page this Question was Asked From

Continue Researching