Looking for Replacement Wheel Stud for Lippert 6k Axle Hub

Question

Question:

I have a 2017 jayco eagle 34.5BHS 5th wheel camper with 6 lug, 6000lb LCI axels. Aluminum wheels. Some of the studs and lug nuts are messed up. What size and length are the studs? Cust. Part 0247642 Variant V000269831 Cust. PO1490957

asked by: Jeremy Z

0

Lippert Trailer Axle Tag
(click to enlarge)

Expert Reply:

Hey Jeremy, for a 6k trailer axle the correct replacement wheel stud would be the part # 7-122. Then for a correct size lug nut you'd want the part # AM90049 and you'd be set. Did the studs of your hub break off?

expert reply by: Jameson C

0

Jameson C.

10/27/2025

Hey Jeremy, how did things go with the new wheel studs and lug nuts for your Jayco Eagle? Your update could make it easier for others dealing with damaged studs on similar axles.

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 5

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 6

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 7

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Looking for Replacement Wheel Stud for Lippert 6k Axle Hub

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching