What is the Lug Nut Torque Specs for etrailer 3.5K Idler Hub Assembly?
Updated 10/30/2025 | Published 02/07/2025
Question:
Recommendation for lug nut torque with these hubs?
asked by: Harold C
0
Expert Reply:
Hey Harold, thanks for reaching out!
The lug nut torque specs for the Easy Grease Trailer Idler Hub Assembly for 3.5K Axles # AKIHUB-545-35-G-EZ-K will vary depending on what your wheel size is and what it's made of. If you check out the linked photo, you'll see that it can range from 55 ft-lbs up to 120 ft-lbs.
As long as you follow the chart you'll be good to go! What size wheels are you using and what are they made from?
expert reply by:
Jon G
0
Lug Nut Torque Specs Chart
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Idler Hub
- EZ Lube
- L68149 / L44649
- Marine Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Correct Replacement for UFP H-1377 Trailer Hub
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Article: Trailer Lighting Requirements
- Q&A: Hub for E-Z Lube Spindle on Boat Trailer
- Article: Trailer Wiring Diagrams
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Article: How to Measure a Trailer Axle
Jon G.
10/30/2025
Hey Harold, did you get a chance to check the torque chart for your wheel size and material on those Easy Grease hubs? Once you confirmed that, did the torque range line up with what you expected? Your update could make it easier for others working with similar hubs.