Do You Have a Picture of the Draw-Tite Hitch DT66KV Installed on a 2024 Chevrolet Equinox EV?
Updated 02/17/2025 | Published 01/17/2025
Question:
Good day, I was looking into purchasing the drawtite hitch for Equinox EV and wondered if you have photo of the hitch installed. I would like to see what it look like before purchase. Thank you,
asked by: Marc
Expert Reply:
Good morning Marc! I am sorry but I have checked with the manufacturer and scoured the internet, however I can not find a picture of the Draw-Tite item # DT66KV installed on a 2024 Chevrolet Equinox EV.
What I can tell you is that the hitch receiver is going to extend directly below your bottom trim. If you look at the picture below and focus on the rear square in the middle of the bumper. The 2" receiver will be directly below that.
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Adding Trailer Brakes to a Little Guy Meerkat Trailer
- Shop: Trailer Wiring
- Q&A: Do I Need to Trim to Install a Hitch on a 2024/2025 Chevrolet Equinox EV?
- Shop: Dexter Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs to 2,200 lbs
- Shop: Roof Rack
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Q&A: How To Determine Left Side From Right Side When Installing Axles With Brakes Installed
- Shop: Brake Controller
- Q&A: Availability of Hitch for 2025 Chevy Equinox EV for Bike Rack
- Shop: Dexter Trailer Hub and Drum Assembly for 2,000-lb E-Z Lube Axles - 7" Diameter - 5 on 4-1/2
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Q&A: Do Draw-Tite & Curt Trailer Hitch Fit 2024 Chevy Equinox EV
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: Is Fascia Trimming Needed to Install Curt Trailer Hitch On 2024 Chevy Equinox EV
- Video: Dexter Electric Trailer Brakes Review
- Video: Review of the Dexter Electric Trailer Brakes
- Video: Curt Echo Under-Dash Trailer Brake Controller Installation - 2021 Chevrolet Silverado 1500
- Video: Curt Discovery NEXT Trailer Brake Controller w/ Custom Harness: The Breakdown
- Video: How to Install: Curt Echo Wireless Brake Controller on your 2020 Subaru Outback Wagon
- Q&A: 7-Way RV and 7-Way Round Pin Brake Controller Output Wire Connection Location.
- Video: Review of the Dexter Trailer Hub and Drum Assembly for 2,000-lb E-Z Lube Axles
- Video: Let’s Check Out the Dexter Trailer Hub and Drum Assembly
- Search Results: trailer hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Lamp Guards
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Trailer Hitch
Joel
2/14/2025
Hi Jerred, Is there a way to tell from the mounting points and dimensions if the Draw-Tite hitch opening will be further back (towards rear of vehicle) than the Curt? Seeing pictures of the Curt installed, it's not only low, it's also far enough underneath the vehicle that an extender would need to be used for a trailer, bike rack, hitch rack etc. Which would reduce it's rated tongue and towing weights. My main hesitation with the Draw-tite is that it would have the same issue. I also haven't been able to find any photos! Thanks