Can Thule Tepui Foothill Rooftop Tent Mount Using T-Slots

Question

Question:

Does the Thule Foothill roof top tent mount using T-slots? Or is the two clamp option the only way to install it?

asked by: Howard

0

Expert Reply:

Hello Howard; the Thule Tepui Foothill Rooftop Tent # TH37HJ is only able to mount on crossbars by clamping on. Would you prefer a rooftop tent that mounts in the top channel of your crossbars? If so, I recommend the Rhino-Rack Soft Shell Rooftop Tent # RR77AP. This is a 2 person tent just like the Thule with a 661 lb capacity and a slightly larger sleeping footprint measuring 85-3/8" long x 51-3/16" wide.

expert reply by: Robin H

0

Thule Tepui Foothill Mounting
(click to enlarge)

Robin H.

11/3/2025

Hey Howard, did you end up going with the Thule Foothill or the Rhino-Rack tent for your setup? It’d be great to hear how the mounting style worked out for you. Your update could make it easier for the next person choosing between these two tents.

Answer 1

Yes you can use the Thule Tepui Foothill Rooftop Tent #TH37HJ, with a roof rack like the Thule WingBar Evo #TH711400, with the feet #TH710401, however if you have a slick top roof, this will not be a viable option. Instead, you're going to need…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 10

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 11

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 12

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Can Thule Tepui Foothill Rooftop Tent Mount Using T-Slots

Featured Help Information

Miscellaneous Media

Continue Researching