Troubleshooting Brake Controller Won't Turn On After Plugging In to 2024 E-450 Tow Port

Question

Question:

I have 2024 e series ford F450 motor home I found the brake controller plug behind the coin tray plugged in the new controller Nothing happens there is nothing on my info screen to activate the controller

asked by: Richard G

0

Expert Reply:

Hi Richard; I'm assuming the screen doesn't even turn on when you plug it in. If that is correct, check for power on the E-450 wiring harness. It could be that you have a blown fuse or the fuse is missing for the brake controller wiring which would explain why nothing happens.

expert reply by: Robin H

0

Richard

12/20/2024

There is power to the plug

Robin H.

12/20/2024

@Richard if you have power at the plug and the brake controller screen won't turn on it is probably a problem with the brake controller. I would reach out to the manufacturer or whoever you bought it from to see about replacing it under warranty.

Answer 1

Your 2017 Ford E-450 van chassis/RV will use brake controller wiring harness #3034-P. Ford only makes this van chassis for the RV and emergency vehicle industries now but the 2017 chassis is the same as the 2014 model year which was the last year it…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 5

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 6

For your 2024 Nissan Frontier I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR. I like the Liberty because it is simple, reliable, and looks great in any vehicle. The main unit installs behind the dash, so only the control knob will…

view full answer...

Answer 7

Hi Richard! The best brake controllers on the market for your 2023 Ford Explorer XLT are going to be from Redarc. They're super easy to use and set up, and they are very reliable. They are the ones to get. Since you said you will be towing a…

view full answer...

Answer 8

Hey Ken! The correct wiring harness depends on whether or not you have the brake controller port/plug. Some models did not include the plug so you will have to check your 2025 Ranger and see. There should be four wires coming out of a large wire…

view full answer...

Troubleshooting Brake Controller Won't Turn On After Plugging In to 2024 E-450 Tow Port

Continue Researching