Brackets Needed To Mount Lippert Pull-Out RV Steps To A Wooden Storage Space
Updated 11/11/2024 | Published 11/09/2024
Products Featured in This Question
Question:
Id like to use these steps to build a retractable access to an attic storage space. Is there a brackets I could purchase to attach the unit to the underside of a wood platform that would serve as a landing?
asked by: Steve
Expert Reply:
Hey Steve,
Steps like the Alumi-Tread Manual Pull-Out Step for RVs # LC432698 are attached directly to the frame using the side brackets. These have a bunch of pre-drilled holes in them to attach to the frame of the RV from below. If you're wanting something a bit sturdier then you can pick up some relocation brackets # LC301704, which would mount to the sides of the step brackets and have a much larger lip to secure to the underside of the wood platform.
Product Page this Question was Asked From
Alumi-Tread Manual Pull-Out Step for RVs - 8" Drop/Rise - 24" Wide - Quad - Aluminum
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 28 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- Aluminum
- Lippert
more information >
Continue Researching
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Are There Hardwired Wall Remotes For A Fan-Tastic Vent RV Roof Vent
- Q&A: P/N TLA8003 Torklift Glowstep Revolution Dimensions
- Q&A: Lippert Solid Step for 24" Doorway
- Q&A: Can 3-Step RV Stairs be Replaced with Quad Step
- Q&A: Recommended Steps for 2015 Montana 5th Wheel Trailer to Make Entry and Exit Easier
- Q&A: Can Reese 16k Fifth Wheel Hitch be Used in 2024 Ram 2500
- Q&A: RV Step Recommendation Where Mounting Bracket is 27-1/2 inches in Width
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: How to Measure for Motorhome Steps
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Which RV Propane Tank Size Do I Need?
- Article: Trailer Wiring Diagrams
Solid O.
11/11/2024
Are there similar brackets of I wanted to use the SolidStep instead? Thanks.