Are Swan-Shaped Equalizers For 2" Wide Slipper Springs Sturdier Than Regular
Updated 12/22/2025 | Published 10/17/2024 >
Products Featured in This Question
Question:
Are these sturdier than the regular equalizers
asked by: Austin C
Expert Reply:
Hi Austin,
Nope, the 10-1/8" Swan-Shaped Equalizer for 2" Wide Slipper Springs # 13-4 isn't sturdier than the rectangle shape like part # TREQ1304, for example. The swan-shaped are just generally used for triple-axle trailers while the rectangle is generally for tandem axles.
Most important is that you get equalizers the correct length, and the same as your current if possible. I have added a link below to our entire selection of equalizers for 2" wide slipper springs for you which you can filter through by length.
Product Page this Question was Asked From
Swan-Shaped Equalizer for 2" Wide Slipper Springs - 10-1/8" Long - 7/8" Center Hole
- Trailer Suspension Parts
- Standard Equalizer
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- 10-1/8 Inch Long
- Tandem Axle
- Triple Axle
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Review of etrailer Trailer Jack - Dual-Pin Two-Speed Square Tube Jack - e45YV
- Shop: etrailer Dual-Pin Two-Speed Square Tube Jack - 20,000 lb Static / 12,000 lb Lift
- Shop: Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 10-1/8" Long Equalizers
- Search Results: equalizer
- Shop: Swan-Shaped Equalizer for 2" Wide Slipper Springs - 10-1/8" Long - 7/8" Center Hole
- Search Results: slipper equalizer
- Search Results: tandem equalizer
- Shop: Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 28-3/4" Lift - 12K
- Shop: Tandem-Axle Trailer Equalizer Kit for 2" Slipper Springs - 13-1/8" Long Equalizers
- Video: The Low-Down on the Swan-Shaped Equalizer for 2" Wide Slipper Springs
- Q&A: How to Determine Correct Replacement Slipper Springs for Triple Axle Trailer With 8,000 lb Axles
- Shop: Dexter Tandem-Axle Trailer Hanger Kit for 3" Slipper Springs - 38" Axle Spacing
- Shop: Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 38" Axle Spacing
- Search Results: hinge
- Search Results: hinges
- Search Results: hydraulic jack
- Search Results: ramp hinge
- Q&A: Troubleshooting EOH Brakes With Hydrastar Actuator Not Working With 2024 Ford F-450
- Q&A: Replacement For Grease Seal 32374 For Trailer
- Q&A: Disc Brake Conversion Kit For 2021 Grand Design Solitude 310GKR With 7,000 lb Axles
- Q&A: Trailer Wiring Harness that Fits 2021 Kia Sorento SX
- Q&A: Availability of Lift Assist for Fold-Out Ramps on Gooseneck Trailer with Beaver Tail
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Most Popular Wheel Bearings
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Trailer Wiring Diagrams
- Article: Rooftop Cargo Carriers


Jameson C.
12/22/2025
Hey Austin, did you end up finding equalizers that matched the right length for your trailer? Knowing what worked could help others comparing the swan-shaped and rectangular styles.