How to Get Furrion Vision S Monitor to Tri View Mode

Updated 10/15/2024 | Published 09/24/2024

Question:

Furrion 7” monitor with 3 cameras. Is there a way to show 3 screens? I only see 4 or 1 selection.

asked by: Mark A

Expert Reply:

Hey Mark, thanks for reaching out!

The Furrion Vision S Wireless RV Backup Camera System w/ 3 LED Marker Light Cameras - 7" Screen # FR98NR has a Tri-View setting that gives you a way to look at all 3 cameras at the same time. I'm linking the instructions for this for you to check out - you can also find these steps on pages 22 and 23 of the Vision S instructions.

expert reply by: Jon G

Quad View and Tri View Settings for Furrion Vision S
(click to enlarge)

Auto Display Settings for Furrion Vision S
(click to enlarge)

Mark H.

10/4/2024

Jon I followed the instructions and can still ONLY see the modes: H Split Quad Split Auto This is a 7 “ monitor Furrion FOS07TADS

Jon G.

10/9/2024

@MarkH I heard back from my contact at Furrion and they want to know if you have the yellow trigger wire connected on the camera when you hooked everything up, or did you cap it off?

Mark H.

10/9/2024

@JonG I did cap off the yellow wire on both left and right side cameras.

Jon G.

10/14/2024

@MarkH My contact is now asking what the serial number is - I guess the tri-view capability wasn't built into some older models of the Vision S (which I would think that's more of a software issue than hardware....but I'm not Furrion) so they would like to verify if that's the case or if there is something malfunctioning.