Replacement Fenders for Demco Kar Kaddy SS Tow Dolly

Question

Question:

Will the DM37FR and DM97FR fit the Kar Kaddy SS

asked by: Randy H

0

Expert Reply:

Hey Randy, the correct replacement fenders for a Demco Kar Kaddy SS is the part # DM87FR for the driver side the part # DR74FR for the passenger side.

expert reply by: Jameson C

0

Jameson C.

2/3/2026

Hey Randy, how did the replacement fenders work out on your Kar Kaddy SS? Knowing which ones fit best could help others looking to replace theirs too.

Answer 1

The difference between the models will depend on which ones you are comparing to the Kar Kaddy SS. The Kar Kaddy SS will have built-in LED lights and a galvanized gray finish. While some of the other models will not have LED lights and some have a…

view full answer...

Answer 2

It all has to do with the axle. The Demco Kar Kaddy SS item #DM9713045 has a steerable axle and the Demco Kar Kaddy X item #DM9713093 has a swivel platform. Both help with tracking behind your motorhome, however the steerable axle will be far…

view full answer...

Answer 3

Although they do look similar, they will not work in place of your Demco 10" brake rotors. Instead, you'd need to use the Replacement 10" Brake Rotor for Demco Tow Dollies #DM03927-92 which is going to be an exact replacement.

view full answer...

Answer 4

The EZ Haul Car Tow Dolly with hydraulic brakes looks like a pretty straight-forward tow dolly that has entry-level quality that get's the job done. We don't carry this tow dolly so I can't speak to longevity but for what it is it seems…

view full answer...

Answer 5

I recommend using the Trailer Valet XL Trailer Dolly with Chain Drive part #TVXL2 to maneuver your Big Tex 70PI-X. This dolly has a drive system so you don't have to physically strain yourself to move the trailer. The trailer is a bit too large…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Replacement Fenders for Demco Kar Kaddy SS Tow Dolly

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching