Replacement Hub for 2010 Triton Jet Ski Trailer
Updated 02/03/2026 | Published 07/01/2024
Products Featured in This Question
Question:
I have a 2010 triton LTWCI jet ski trailer. Hubs have 44643 bearings. Bolt pattern is 5 on 4 1/2. What pre greased hubs and bearings do you recommend. Also, there’s no washers between the castle nut and bearing. Is this acceptable??
asked by: Glenn B
0
Expert Reply:
Hey Glenn, the bearing numbers you mentioned indicate that you have a 2k axle so for a hub with that capacity and the correct bolt pattern you'd want the part # 8-258-5UC1-EZ which comes pre-greased.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44643
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.00 Inch I.D.
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: What Replacement Rotors and Brake Pads do I Need for My Kodiak Disc Brakes K2HR12A11-120DW?
- Q&A: What Is The Span Or Usable Length Of RV Designer Hitch Pin - 1/2" # RD83GR
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What is Best Trailer Jack for Use in Saltwater
- Q&A: How Do I Know If My 10k AL-KO/Hayes Brake Caliper Is For The Right Or Left Side Of A Trailer
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Looking To Replace 4-Lug Hubs With 5-Lug
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: What is Difference Between Trailer Bearings L44649 vs L44643
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
Jameson C.
2/3/2026
Hey Glenn, how did the pre-greased Dexter hub work out on your Triton trailer? Did it fit well with your existing bearings and bolt pattern? Your update could make it easier for the next person with the same setup.