How Can I Make a Bearing Buddy Fit Tighter?
Updated 06/12/2024 | Published 06/05/2024 >
Question:
I installed new bearing buddy’s on my original hubs after bearing and race replacement. And after I realized I had too much slop in my bearings I had to remove the bearing buddy to adjust my bearings. Now the bearing buddy can be removed by hand after installing it again and I am afraid it will fall off while trailering down the road. During removal I used a dead blow hammer to tap off the bearing buddy while rotating the hub so I don’t think I could have wallowed out the hub mating surface for the bearing buddy. Is there any solution to get a tighter fit? What are my options.
asked by: Austin K
Expert Reply:
There's no solution to making a bearing buddy like item # BB1781 tighter. We tell people to use a mallet the same way you did to remove them. A deadblow hammer is going to hit harder. You might've bent something but other then replacing it there's nothing you can do to fix it.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.78 Inch
- 3000 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Article: Best Bike Racks for Electric Bikes
- Search Results: marine bearing grease lubricants sealants adhesives
- Search Results: bearing buddies
- Q&A: Looking For Bearing Buddies For A 1988 Boat Trailer With 14" Single Axle Wheels
- Q&A: Bearing Buddy Sizes Compatible for Hub 2 Inch Inner Diameter
- Shop: Dexter Grease Caps with 1.99" OD - Fits 7" and 10" Hubs - Zinc-Plated Steel - Qty 2
- Q&A: Bearing Buddy for 1.98 and 2.13 Inch Trailer Hub Center Hole
- Shop: Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated - Qty 2
- Shop: Benton LittleShift Bike Rack for 1 Bike - 2" Hitches - Wheel or Frame Mount
- Shop: Thule EasyFold XT Bike Rack for 2 Electric Bikes - 1-1/4" and 2" Hitches - Frame Mount
- Shop: etrailer Bearing Protectors w/ Covers for 1.78" Hub Bore - Chrome - Qty 2
- Shop: Kuat NV 2.0 Bike Rack for 2 Bikes - 2" Hitches - Wheel Mount - Gunmetal Gray
- Shop: Trailer Wheel Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer tires and wheels
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Search Results: trailer wiring
- Search Results: trailer jack
- Shop: Brake Controller
- Search Results: trailer lights
- Shop: Base Plate for Tow Bar
- Shop: Gooseneck Hitch
- Shop: Fifth Wheel Hitch
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Q&A: Replacement Grease Seal for Dexter Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Are The Goodyear Duratrac LT225/75R16 Trailer Tires Or Truck Tires?

