Looking For Bearing Buddies For A 1988 Boat Trailer With 14" Single Axle Wheels
Updated 06/12/2024 | Published 06/04/2024
Products Featured in This Question
Question:
1988 boat trailer with 14 inch single axle wheels I got 1.7/8 inch with a tape measure but I dont have a calaber tool.
asked by: Norman
Expert Reply:
Hey Norman, it sounds like you are looking for bearing buddies for your boat trailer. Without a caliper measurement it is going to be difficult to accurately recommend the correct parts. There are a few potential sizes that could appear to be 1-7/8" to the naked eye. The Bearing Buddy pair you were looking at, part # BB1781, fits a 1.781 inch hub bore. I do suggest that you take a caliper such as part # PTW80157 to double check your hub bore measurement. Feel free to post your findings in the comment section below and I am happy to make a recommendation.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.78 Inch
- 3000 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Search Results: marine bearing grease lubricants sealants adhesives
- Search Results: bearing buddies
- Shop: etrailer Bearing Protectors w/ Covers for 1.78" Hub Bore - Chrome - Qty 2
- Article: Best Bike Racks for Electric Bikes
- Shop: Dexter Grease Caps with 1.99" OD - Fits 7" and 10" Hubs - Zinc-Plated Steel - Qty 2
- Shop: etrailer Bearing Protectors w/ Covers for 1.98" Hub Bore - Chrome - Qty 2
- Shop: Grease Cap, 1.99" OD EZ Lube Drive in with Plug - Qty 2
- Shop: 2" Lubed Dust Cap & Rubber Plug - 1.99" x 1.40" x 1.18" - Qty 1
- Shop: Benton LittleShift Bike Rack for 1 Bike - 2" Hitches - Wheel or Frame Mount
- Q&A: How Can I Make a Bearing Buddy Fit Tighter?
- Q&A: Bearing Buddy for 1.98 and 2.13 Inch Trailer Hub Center Hole
- Q&A: Bearing Buddy Sizes Compatible for Hub 2 Inch Inner Diameter
- Shop: Thule EasyFold XT Bike Rack for 2 Electric Bikes - 1-1/4" and 2" Hitches - Frame Mount
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Q&A: Determining Which Diameter to Measure for Bearing Buddy
- Q&A: Recommended Bearings for a Ranger Boat Trailer
- Q&A: Looking For Caliper To Replace Discontinued Tie Down Engineering 46802 Caliper
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Replace an RV Roof Vent Cover
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Gooseneck to 5th Wheel Adapters
Norman
6/12/2024
Thanks, I got a number from the bearing. So I think I got a size from that number 1.9