Recommended Metal Valve Stems Compatible With Internal TPMS

Question

Question:

I want to change my 2023 Sprinter 3500 inside dually wheels to metal valve stems and purchase this TPMS. I have been unable to find a metal valve stem that is compatible with an internal TPMS. Do you have any recommendations? Thanks

asked by: Rod D

0

Expert Reply:

Rod, you could use the low through sensors like the Flow Through Tire Sensors for TST TPMS # TST-507-FT-S2 TST with the TPMS for RVs # TST-507-FT-4-C, which is compatible with metal valve stems.

expert reply by: Bryce D

0

Answer 1

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds. You will get a visual and audible alert when the monitor receives the signal from your tire sensor is either below your pressure or the temperature exceeds the maximum setting.

view full answer...

Answer 2

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

view full answer...

Answer 3

The psi and temperature are going to change based on the tire and the temperature outside for your ST225/75R15 tire like the Westlake #LHWL304. So it is not surprising at all that the psi climbed based on your long trip as well as the significant…

view full answer...

Answer 4

If your 2019 Chevy Silverado 2500 HD Duramax already has a built in TPMS, I don't think you'd need to add the additional sensors to the TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors #TST-507-FT-4-C, but I…

view full answer...

Answer 5

If you have valve stems with a metal body like the Americana Metal, Bolt-In Valve Stem part #AM20906 then you will want to use flow-through sensors but if you have valve stems with a rubber body like the Americana Rubber, Snap-In Valve Stem part…

view full answer...

Answer 6

The TST TPMS for RVs part #TST-507-FT-4-C that you was basically designed to always use the signal booster that comes with it so I would have to recommend you use it for your setup.

view full answer...

Answer 7

According to my research the TST Signal Booster / Repeater #TST-507-R won't work. People have tried different aftermarket solutions but none of them have been able to communicate with the OEM TPMS on the newer GM trucks as of yet. I read that GM…

view full answer...

Answer 8

The signal booster of the TST TPMS for RVs #TST-507-FT-4-C is required for use and would be needed with your setup that has a 35 foot 5th wheel. The exact range isn't listed but it was designed for applications just like yours so it would work…

view full answer...

Answer 9

I reached out to my contact at TST and all of their TPMS systems like the TST TPMS for RVs - Color Display #TST-507-FT-4-C use sensors that are accurate to within +/- 3 PSI. This is a very minor variance so it is not something I would worry too much…

view full answer...

Answer 10

Yes, we have the TST TPMS for RVs #TST-507-FT-4-C available with the grayscale display listed as part #TST-507-FT-4 on our site. This includes the signal booster and the 4 flow through tire sensors as well.

view full answer...

Answer 11

I recommend checking out the TST TPMS for RVs - Color Display - Signal Booster #TST-507-FT-4-C. This is my personal choice if given one because it's simple to use, and you don't have to remove the sensors every time you air up. It may not…

view full answer...

Answer 12

I reached out to the manufacturer, TST, about the Signal Booster for TST TPMS #TST-507-R, who told me the following: 1) The repeater does come with an inline fuse on the positive (red) wire. 2) All current repeaters do come with ring terminals. 3)…

view full answer...

Recommended Metal Valve Stems Compatible With Internal TPMS

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching