Replacement Voyager Camera System For A 2005 Gulfstream BT Cruiser Class C Motorhome

Question

Question:

Hello, I am looking for a replacement for my black and white backup camera monitor, Voyager AOM561. It is original equipment on my 2005 Gulfstream BT Cruiser class C. The monitor is located in the sun visor. If that monitor is not available, is there something else I could substitute? If not, what wired camera/monitor system do you recommend? I would prefer a wired system that would plug into the existing wiring running to the back of the coach. Thank you.

asked by: Richard

0

Expert Reply:

Hey Richard,

The Voyager AOM561 has been discontinued so you'd be looking at replacing both the camera and monitor because they made their different camera generations incompatible with each other. With you wanting to stick with your current wiring the only option is going to be the Voyager RV Backup Camera System w/ Night Vision # VOM43HDCL1B. This comes with the same 4-pin connectors so you'll be able to easily swap out the camera and monitor and keep your wiring.

expert reply by: Kevin C

0

Answer 1

The Optronics LED Clearance or Side Marker Trailer Light is available in Red #MCL0030RBB and Amber #MCL0030ABB. These are the closest replacements to the Glo Brite 122r/122y lights you have. The lights only have one LED diode versus the 3 in your…

view full answer...

Answer 2

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The SuperSprings Custom Suspension Stabilizer and Sway Control Kit will install above the leaf springs but below the brackets used to engage the overload springs - I believe that's what you mean by the bracing setup. We have a sample installation…

view full answer...

Answer 5

The Timbren Rear Suspension Enhancement System #TGMRC55 that you referenced have been confirmed to fit the 2008 Chevrolet Kodiak 5500. These jounce-style suspension enhancement springs will help provide a level ride for your RV if the rear of the…

view full answer...

Answer 6

Although they are for the front axle, the SumoSprings #SSF-281-47 are confirmed to fit your 2008 Kodiak C5500 Motorhome. Unfortunately, for the rear axle the only comparable option is the Timbren Rear Suspension Enhancement System #TGMRC55. There is…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Replacement Voyager Camera System For A 2005 Gulfstream BT Cruiser Class C Motorhome

Products Featured in This Question

Continue Researching