Replacement 7" Monitor For A Furrion FOS48TAPK-BL Camera System

Question

Question:

I bought a used trailer with a Furrion FOS48TAPK-BL system but no monitor. Can I get a 7 inch replacement? and what is the part number for it.

asked by: Bruce B

0

Expert Reply:

Hey Bruce thanks for your question. You absolutely can get a replacement 7" monitor that will work with the Furrion FOS48TAPK-BL camera system on your camper. For the 7" monitor it will be part # FR47FR. You will also need a Replacement Furrion Monitor Power Cable # C-FOS07TAPK-006 and a Replacement Suction Cup Mount # FR79SR, if you don't have them already.

expert reply by: Jesse M

0

Brucee B.

3/19/2024

OK the monitor works fine but I can not get the camera to pair. I may need to replace it as well. What would be the part number for one?

Reply

Jesse M.

3/19/2024

@BruceeB The new camera will be part # FCN48TASF.

Reply

Answer 1

Yes you can upgrade the 5 inch monitor of your Furrion Vision S system with a 7 inch one with the part #FR47FR and you'd be set.

view full answer...

Answer 2

The Furrion cameras, like what comes in the part #FOS43TASF that replaced the part you referenced, are only compatible with their specific monitors. If you are looking for a camera system that allows you to use your smartphone as the monitor then I…

view full answer...

Answer 3

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 4

A couple of things to check when trying to pair monitor to the camera for the Furrion Vision S #FOS43TASF. First make sure that the monitor is close enough to the camera. Next make sure that the camera is receiving power (indicated by LED light on…

view full answer...

Answer 5

Since the discontinued Furrion Digital Wireless Observation System FOS48TAPK-BL (similar to part #FOS43TASF) plugs into a 12V accessory outlet like what comes with the kit #RM-9332 you just need to make sure your 12V accessory outlet has power when…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

To pair the camera and monitor parts of your Furrion Vision S observation camera system #FOS43TASF you can try pressing the button on the bottom of the camera. Please refer to the linked photo. First disconnect power to both camera and monitor…

view full answer...

Answer 8

The Replacement 7" Monitor for Furrion Vision S Wireless RV Camera System Item #FR47FR will replace your current 4.3" Monitor and allow you to add additional cameras to your system if needed.

view full answer...

Replacement 7" Monitor For A Furrion FOS48TAPK-BL Camera System

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching