Replacement Hub For Trail Star Boat Trailer With 5 Lugs For Threaded Wheel Bolts and L44649 Bearings

Question

Question:

I have a bass tracker pro 185 with a trail star trailer. Need the hub for the trailer. Bearings is a l44649 inner and outer. Which hub do I need ?

asked by: Nick W

0

Hub From Tail Star Boat Trailer
(click to enlarge)

Expert Reply:

Thank you for including the image Nick as that helps me see your hub has the 5 lugs and threaded holes for wheel bolts. The Dexter Trailer Idler Hub # 008-258-04 is currently the only hub we have for your spindle size which has the threaded holes. This hub comes with the races pressed in but you will need 2 of the Bearings # L44649. a Grease Seal # 10-9 and either a EZ Lube Grease Cap # DE69YR, Standard Grease Cap # F001518 or we have the Bearing Buddy # BB1980A you can upgrade to.

We currently only carry the Wheel Bolts in a 4-Pack with 60 Degree # RG02-020 or 90 Degree # RG02-040 cones.

expert reply by: Bud M

0

Answer 1

The inner diameter of the Stainless Steel Drive-In Grease Cap w/ Plug #DE69YR measures 1-7/8" (see attached).

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Replacement Hub For Trail Star Boat Trailer With 5 Lugs For Threaded Wheel Bolts and L44649 Bearings

Products Featured in This Question

Continue Researching