Will The Gas/Water Regulators Need To Be Replaced When Swapping To A Furrion Tankless Water Heater

Question

Question:

If replacing Atwood G10-3E with this FR68SR, will it require changing any gas or water pressure regulators?

asked by: Alan S

0

Expert Reply:

The Furrion RV Tankless Water Heater # FR68SR requires a 11” WC minimum to 14” WC maximum (gas pressure) and 7.2psi minimum to 65 psi maximum (water pressure), which fall within industry standards so your current gas and water regulators will be good to use still.

expert reply by: Kevin C

0

Answer 1

To replace your Suburban SW12DEL RV Water heater with a tankless water heater I recommend the Furrion RV Tankless Water Heater 60,000 BTU #FR68SR. This unit features a heating capacity of 13,000 - 60,000 Btu, well above that of your Suburban. The…

view full answer...

Answer 2

The Furrion RV Tankless Water Heater #FR68SR can definitely replace your old Suburban SW12DE water heater. This is a great choice and will be an upgrade you're happy with. This tankless water heater has an endless supply of hot water so you never…

view full answer...

Answer 3

Hi Wes, All newer water heater models are transitioning to smaller sizes as the technology gets better so you'll likely have a gap regardless of which unit you choose to go with. There's typically framing around the water heater so you'll…

view full answer...

Answer 4

In regards to the Furrion RV Tankless Water Heater part #FR98SR, the owner's manual recommends using non-metallic flexible hoses for the gas supply and PEX for the water supply. The gas fittings on the unit are 3/8" female flare and the…

view full answer...

Answer 5

All of the RV regulators we carry are going to work down the output pressure to 11" water column. That pressure will always stay the same but the amount of BTU's you can spread between the appliances can vary depending on the regulator. For…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Answer 8

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 11

Hey Jack! You can use the Kodiak Disc Brakes #KOD67FR as a replacement as long as you have a #84 spindle on that trailer. These use #L68149 inner and #L44649 outer bearings so you need to make sure that matches what you have now. If you aren't…

view full answer...

Answer 12

Hey Bryan, I would go with the Kenda Karrier KR53 part #KE72EV to use as a spare on your 2012 Jayco Jay Flight travel trailer. Its the correct size wheel and tire that you need, it's the Load Range D you need, and also is the best priced option…

view full answer...

Will The Gas/Water Regulators Need To Be Replaced When Swapping To A Furrion Tankless Water Heater

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching