DH Cradle for Yakima HangTight Bike Rack for 6 Bikes

Question

Question:

What is the DH cradle part for the Y39GR?

asked by: David W

0

Expert Reply:

To install a bike with a dual-crown suspension fork on the Yakima HangTight Bike Rack for 6 Bikes # Y39GR you need the DH Cradle # Y99GR.

Please note the DH cradle cannot be installed in the position closest to the left side of the mast per Yakima.

expert reply by: Jon G

0

DH Cradle Installation on Yakima HangTight Bike Rack
(click to enlarge)

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Hey Jason! The etrailer #e69ZV and Curt hitch do share the same design. Our hitch has the same restrictions so you do not want to use it for that bike rack. Instead, you can use the TowSmart Trailer Hitch Receiver #TS48QR. This also has a higher…

view full answer...

Answer 3

Hello Hatem; it looks like the only models that can handle 350 lbs are the Adventure and TRD Off-Road. Your 2024 Toyota RAV4 LE is limited to the 150 lbs unless you can get Toyota to say otherwise, so the #B82FR will be too heavy with your bikes. The…

view full answer...

Answer 4

First, thanks so much for the purchase of the Draw-Tite Sportframe Trailer Hitch Receiver #24966 for your 2017 Toyota Prius, and I'll go over each of your questions so you can choose the best option between the Camber and RidgeBack, which are the…

view full answer...

Answer 5

Hey Jan, yes that's correct and while they might look the same, they are not. The biggest thing is the Thule OutWay Trunk Bike Rack for 3 Bikes #TH56BV is a hanging rack, and #TH65JV is a platform rack. These racks do have the same per bike…

view full answer...

Answer 6

I would be happy to help you. I took a look at the dimensions of the Draw-Tite Max-Frame Trailer Hitch Receiver item #76020 you installed on your 2021 Mazda CX-9. From the hitch pin hole to the bumper is 7" so that hitch does sit pretty far back…

view full answer...

Answer 7

Hey Jon! The 2018 E-Series Cutaway does not have a custom fit hitch available. What you need is a universal hitch like the Draw-Tite Ultra Frame Service Body Trailer Hitch #41990-07. This is a Class V hitch with a 2" receiver and a weld-on…

view full answer...

Answer 8

David, for your 2018 Ford E-450 I recommend checking out the Curt Class 5 Universal Weld-on Hitch w/ Brackets #C47CR. This trailer hitch will fit on frames that have a width of 18" to 44", has a max weight capacity of 16,000 lbs, and a max…

view full answer...

DH Cradle for Yakima HangTight Bike Rack for 6 Bikes

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching